Build Daily

Latest

August 24, 2016 23:11

Warming of the floor in the garage

Good afternoon!

My name is Alexander.The next 5-10 minutes, I will share with you my experience of building dedicated to floor insulation in the garage.The motivation for writing this post for me was the communication between the same as I, "diy", which for fun like: handicrafts, repair and build.

happy to take you to all questions in the comments, and I will be glad to new ideas, which will serve as a breeding ground for improvement of my designs.

In this article I want to tell you, dear users StroyDay.ru portal about how I was doing insulation in the floor in the garage with his hands.The article will not do very much expanded, only the main points that enable you to understand how is the insulation of the garage.So there you go.

Warming of the floor in the garage with his hands

Warming of the floor in the garage with his hands

Materials for insulation:

So, before you get started, I decided to go to the store and buy the following materials:

  1. wooden bar (5/5 cm)
  2. Building board DSP
  3. Screws long 7cm
  4. Polyurethane foam
  5. Plastic film
  6. cutter foam or a sharp knife
  7. foam (the material for insulation)
  8. screwdriver
  9. Drill
  10. Building level
  11. Vacuums
  12. Drill

total amount that was spent on all the necessary tools for the work was about 3 thousand rubles.The main cost item - a foam.DSP boards - have been borrowed from the old cabinets.

I must say that the soil to insulate the floor in the garage for me was - the desire for comfort.This garage will be my motorcycle (biker I), which I love and cherish repair, even in winter, and walking on capital garage winter boots are not the most pleasant thing, that actually this was the reason for the warming of the floor.

Step floor insulation technology in the garage

Step 1.

To proceed directly to the insulation initially took away all the trash out of the garage, which bars the us access to the work surface.

The situation in the garage before work

situation in the garage before work

Sex in a garage initially was as follows

Sex in a garage initially was as follows

Garage to warming

Garage warming up

Step 2.

lay plastic wrap around the perimeter of the garage to makewaterproofing surface.

Set the wooden blocks, which are pre-napilivaem apart.

Install bars across the garage surface

Install bars across the garage

surface very important point: the installation of the bars and their installation must be pre-determined by the level of construction, becauseIt depends on the quality and level of the floor.

After the wooden blocks set for solid fixation, "sadim" our bars on the mounting foam.

Installation of wooden bars across the insulated area

Installation of wooden bars across the insulated area

Note that before pouring assembly foam under the bars ensure their tight fit between them, becausefoam during drying can disturb the floor level.

Ideally, after the final drying foam should be checked again using the spirit level the surface of the guide rails in the case of sudden changes to adjust the level.

Step 3.

We begin to lay the foam into the grooves

start to lay the foam into the slots

Styrofoam - is an excellent insulating material, which we will use for thermal insulation.

foam technology stacking:

  1. initially cut out foam with a cutter and put it in the grooves (installation pattern, as did I can see in the figure above).
  2. For additional insulation can also propenyl vacant lots (as I said the main part of the cost of the floor will be insulation foam).

Step 4.

Warming of the floor in the garage

Warming of the floor in the garage

ulozheniju foam is as follows (pictured above).Now that the installation is completed start packing foam polyethylene film again.

A general view of the structure in step 4

overall view of the structure in step 4

Step 5.

We begin to sew up the floor with the help of DSP

start to sew up the floor with the help of DSP

Paul sutured with screws and screwdriver

Paul sutured with screws and screwdriver

The floor in the garage is insulated

Sex in the garage is insulated

Summary and conclusions after a year of operation

My review article about the warming of the floor in the garage is over.As you can see 1/4 of the floor was insulated, then I was waiting for the same type of work.I want to say that the floor on my feelings get very warm and safe, as they say wait and see.

I will be glad to your feedback and comments on the results of my work.