Houses made of chopped logs - especially construction

Log of chopped logs - structure characteristic

Blockhouse of specially selected logs will be easier to build.The main feature of this building material is the difference in diameters of the inboard (thicker) and apical ends.In contrast to the logs, having equal thickness over the entire length, chopped to a certain characteristic taper.

In connection with this feature of the construction is carried out with the alternate setting in each crown on thick inboard thin apical side, from the basement to the upper belt.Due to the structure of the material is almost untouched, the house of chopped logs is significantly greater service life, and the wall material is less susceptible to environmental influences.

Minimal processing logs before installation significantly reduces the total cost of the construction, thus "closing" the microscopic structure of the trunk fibers for moisture and external influences, practically without requiring additional external processing.

However, the surface characteristics of the material (roughness, and the difference in diameters endings) do not allow to achieve the perfect look, typical of the logs.The shrinkage of the house is up to ten percent of the height and the time needed up to one year.

House of chopped logs - valuable tips on building

Log cabins of minced logs are built on traditional technology and each element is adjusted at the place of laying, so difficult is achieved tight abutment crowns.An important factor for small heat loss is the exact fulfillment of the longitudinal slot, which requires quite a lot of experience and skill.

Quite often for the walls of chopped logs used external and internal facing of modern materials, such as saydingovymi panels.

When felling a tree otesyvaetsya under bracket and individual (long and protruding) saw off the ends of the logs after installation on site.When this carcass can be carried out "in leg" or "oblo".The first method applies only to the trunks of the same thickness, the second cup can be positioned up or down.

Construction of houses of chopped logs has a number of features.The first crown, also known as the accountant, is made from the highest quality materials and it is often not even otesyvayut.An obligatory condition that increases the strength of attachment of crowns, is to use every meter length of the wall of special spikes.Merging of logs for the walls of greater length, if necessary, it is carried out in a straight spike.

experts recommend arrange in such long lateral walls of the interior partitions with mandatory binding "in oblo".Location of interior walls it is recommended to do at a distance of no more than seven meters, taking into account the thickness of the timber outer walls of the twenty-two centimeters.This distance can be increased up to nine meters in diameter in a timber within twenty six centimeters.

House of chopped logs - proceed to the construction

Before starting work material for the carcass is marked, which is carried out pre-installation.Thereafter, it is parsed again.It is recommended before setting off walls of the house, first prepare his foundation.Technology installation of walls on poles and then performing a foundation can not provide them with the required level of quality.

Practice has shown that properly made log cabins "in oblo" cup up, may be hundreds of years.Qualitatively considered trunks of trees, harvested in winter.An important feature of the device of the roof for the house or baths of chopped logs are overhangs at least half a meter with high-quality roof.It is recommended that the outer casing on the corners of log cabins.It provides additional insulation and protection from wet and rotting of these angles.

believed that the worst form of a longitudinal groove is triangular, and the best form is considered to be oval.It provides a more dense Covering the lower rim along its entire length.Therefore, after the sampling groove on each log is necessary to inspect the density of its fit and correct errors if necessary.

width of the groove is chosen depending on the prevailing winter temperatures.Thus, when frost and thirty degrees centigrade is necessary in a groove twelve centimeters.And for forty-degree frosts to do a groove width of not less than sixteen centimeters.Of course, ultimately it affects the height of the walls and the amount of material required.

aforementioned spikes mezhventsovogo connections are installed in the special slot.Spikes are made of 25 mm board length up to fifteen centimeters and a width of not less than six.Given the dry socket depth under the thorn must provide two to three centimeter margin.

best tool for the job with chopped log is still considered the ax, Struga, hammer, chisels and gouges.and portable circular saws are often used.In general, for the work you will need the appropriate Carpentry tools, power tools complemented with the necessary working nozzles.