How to make arch of the drywall video

Arch interior doors in the opening mounted after the dismantling of the door and walls.It is also necessary to align the walls of plasterboard or plaster.Then, on the leveled surface mounted profiles for drywall.For this purpose, the end of the opening you need to drill holes.Straight horizontal and vertical profiles are fixed with screws and dowels in increments of 10 cm. The profiles have to be mounted with a recess to drywall was in one plane with the wall.

arch consists of three parts - two arched plane with the cut semicircles and lower curved strip of drywall between them.To make better use of plasterboard planes 12 cm thick, while the bottom - 10 cm. The width of the sheet of drywall, which is cut out of the arch, should be slightly more than the width of the opening.Contour arch - a semi-circle with a diameter equal to the width of the doorway.

to draw a contour arches can be used flexible plastic nut.Secure it in the corners, through the center of a rectangular sheet of drywall draws the contour of the arch.Cut most convenient jigsaw.These arches are attached to the plane of the guide profiles with screws.Below the video how to make an arch made of plasterboard with their hands, visual and detailed instructions.

Widget from SocialMart

to the bottom of the curved arches and install the guide profile.On the walls of the profile incisions made beforehand (you can use metal shears) from step 3 cm - 5 cm, depending on the radius of curvature.The profile can be easily bend and fasten screws to the main structure.

then cut to size strip of drywall.To bend it with the desired radius on one side made punctures.It is convenient to use a needle roll, but you can also use an awl.Thereafter, the strip needs to be wetted with water.Moistened with a broad brush you need to walk on the surface of the gypsum board 3 times.Then put the strip at an angle, for example, the opera on her stool, and leave for a while.Wet drywall strip bends under its own weight.The resulting bent strip is mounted to the main structure with screws.

All cap screws must be recessed into the drywall.On the contour of the finished arch fixed perforated angle.After this, the entire structure of the soil and zashpaklevyvayut.After drying putty surface is polished.Now Arch is ready for further finishing:. Painting, walls pasting wallpaper, etc. Watch the video and anchoring material.

How to make arch of the drywall video

Video how to bend and wet drywall