Structural Stucco - to make the most difficult, but possible !Let's try ?

structural plaster - applying technology (helpers and tools)

Visually shows the application of structural plaster on different video viewing which can greatly help you understand the process.

So, we need the following tools:

• plastering trowel need for mixing mortar and laying it on the falcon,
• falcon duralumin used for the application of planned, its alignment and smoothing irregularities,
• bucket plaster used for the spraying of the solution onto the surface,
• scraper metal required for high-quality cleaning of the surface,
• wooden trowel (350 and 800 mm) are used for leveling and final smoothing the outermost layer of the working solution,
• brush-CEILING KMA-2 may need to soak and wash contaminated sites,
• trowel need to smooth skim layer,
• grater wooden and felt will be used to grout skim layer,
• rule Bound for quality control plaster is also used for leveling primer layer,
• hammer nasekaniya brick and concrete surfaces,
• Bouchardneed to handle structural plaster or dent the surface,
• plaster knife is useful for splitting and trimming shingles.

Decorative plastering walls coated with a different texture

Let's start with the most simple - learn to get monochromatic block wall surface.Usually used for this decorative plaster, whose surface structure is different depending on the grain size fractions.

there are two ways to obtain relief surface.

• Using the properties of the finished material.

gain material with a granular fraction (1 to 5 mm) for the first embodiment.Working inflict mass of stainless steel trowel by hand.Give dry layer and obtain a textured surface, which view is entirely dependent on the size of the grain fractions.

characteristics of some of the structural plaster mixes allow you to work the foam or wooden float, which will help to create on the surface of the wall structure of vertical, diagonal or circular grooves, much like a shell rock.

• Experiments with application technology.

second option involves obtaining a decorative coating by coating the surface of a homogeneous material, and texture of the area itself is given through the use of special tools.

sequence of work to create a plaster layer

Complete plaster layer is achieved by applying a scratch coat, followed by priming the surface and creating the final skim layer.For wooden walls of spray thickness should not exceed 9 mm, stone, brick and concrete - not more than 5 mm.Running obryzg on pre-wetted surface manual for spraying or brushing.

Through subsequent primer, also observe the permissible thickness of the layer, it should not exceed 7 mm for lime and lime-plaster solutions and 5 mm mortars.

thickness of the latter, the skim layer, leveling and grouting of the past with felt float, for decorative surface structure should be 4-7 mm.

evenness of the finished surface of the control rule.