Build Daily

Equipment

August 12, 2017 18:06

Unpleasant smell in the washing machine : the causes , how to remove , dispose and remove

click fraud protection
Unpleasant smell in the washing machine
  • Why do I get rotten and unpleasant smell?
  • How to remove the smell of improvised means?
  • How to get rid of the smell by replacing the rubber ring or a hose?
    • Replacing rubber sleeve
    • Replacement drain hose
  • Tips and Prevention

Washing machine - an indispensable assistant in the economy, without which it is difficult to imagine modern life.However, sometimes this unit causes serious inconvenience.Disadvantages of these are not always associated with mechanical failure.It also happens that the washing machine is working properly, but it annoys the household of an unpleasant odor, which not only settles on things, but extends throughout the apartment.

Most often, it affects older machines that are already many years in service.But sometimes exude unpleasant odors begins a completely new technique.On why this happens and how to fight it, read our article today.

Mould in the washing machine

Why do I get rotten and unpleasant smell?

reason of odor can be determined, correctly identifying its source.To find bad place, you have to carefully examine all the basic elements of the washing machine.

where the smell is felt?

Why did he come from?

How to get rid of it?

rubber gasket hatch

formation of mold and mildew due to the fact that after washing the cuff is not wiped dry and cleaned of debris

Thoroughly disinfect the gasket using an antiseptic solution;if necessary, this item can be replaced

container for supplying powder and conditioner

mold and accumulation of residues of household chemistry

Wash the container with soap and hot water to clean the place of attachment;handle antiseptic

drain hose

Education blockage, which can be the cause of limescale, detergent residues or small foreign objects

Blow through the hose, and then rinse it in a large amount of warm water;if necessary, you can use a thin rope

Release sewage

clogging Education

sewers Clean clogged using sanitary rope and special funds on the basis of acid or alkali

drain pump

Ingestion of foreign objects drain system

Remove the obstacle and well-cleaned item;if the pump has worn, you can replace it with a new

tubular heating element

structure degradation caused by hard water or aggressive detergents

remove plaque, and if the heater has already come into disrepair - buynew

How to inspect the drain hose for the presence of mold, look at the video.

How to remove the smell of improvised means?

In the struggle with unpleasant smells, the hostess used not only antiseptics and detergents, but also proven popular recipes.We want to share with you a simple way to eliminate malodorous scents emanating from the washing machine.

Required Accessories:

  • soft cloth or sponge;
  • dishwashing detergent;
  • toothbrush;
  • laundry detergent;
  • bleach;
  • baking soda;
  • acetic acid;
  • if necessary - special cleaning agent.
Cleaning the washing machine

may cause an unpleasant smell is the lack of care for the washing machine.In this case, it is necessary to hold the sanitary processing of all available items stiralki:

  1. Open the door and thoroughly wash it on both sides of dish detergent.Clean cracks and joints using a toothbrush and soap powder.
  2. Remove the container for delivery of detergent, rinse it under running water and dry.
  3. Fill the feeder portion of a laundry detergent and start the wash cycle without any laundry.Choose a high temperature - not lower than 90 degrees.
  4. If the previous step does not return any results, try to repeat the same procedure with bleach.At this time, use a double portion, and pour it directly into the drum.
  5. Inspect the unit for the formation of mildew.Affected locations treat with vinegar or baking soda solution.If the mildew reappears, it is possible, these elements should be replaced.

Technique cleaning washing machine is shared with you Natalia Gorbatova in the following video.

How to get rid of the smell by replacing the rubber ring or a hose?

One of the most common causes of bad breath - is the appearance of mold and mildew on the rubber and plastic parts of the washing machine.If treatment with antifungal and antiseptic means no results, these elements have to be replaced.

Replacing rubber sleeve

First you need to dismantle the unusable part.We release it from the two clips - plastic and metal.Once removed the first clip (acting with a screwdriver), release the outer part of the cuff, causing pre-marks which we will strengthen the new part.

Once dismantled the old surface must be cleaned and degreased place fasteners.Next we put on the edge of the new seal tank.We must act from top to bottom (in this case pay attention to the layout).To reduce resistance to use a soap solution.By setting the cuff, we return to the place of the two clamps.

clearly see the process of replacing the cuff you can from the video channel "Jeka RoveR".

Replacement drain hose

If there is a need to replace the drain hose, the sequence of actions will depend on the model of the washing machine.The fact that different manufacturers have the item placed at different places of the unit.Thus, access to the drain hose can be obtained through the front, rear, bottom or side panel of the washing machine.For more information about this can be found in the instruction manual.

Deconstructing the drain system, the camera is fixed on each step, then to reproduce everything in reverse order without any problems.Disconnect the hose from the pump, clean from dirt and degrease the mounting location.Then attach the new part.Before you return to the place of the panel, test the connection for leaks.

Tips and Prevention

  • For washing machines from the inside instead of bleach and laundry detergent, you can use special tablets designed for use in dishwashers.
  • Do not rush to close the door immediately after the wash.First, dry the drum and rubber sleeve.Remove debris and leave the door ventilated for several hours with the door open.Never lock the door until it clicks, even saved a small gap to the inside does not accumulate moisture.
  • Periodically clean from scale and other contaminants metal parts of the washing machine, including the heater and the drum.To this solution may be used acetic acid or citric acid.
  • Do not exceed the recommended dosage of detergent, bleach and conditioner.Surplus of these funds can cause unpleasant odor.
  • Take care about the quality of supplies.Do not use the cheapest washing powder, which is insoluble in water and deposited on the internal elements of the washing machine.Also, watch out for the quality of tap water.If it is too stiff, set flow filter.

What you should pay attention to the prevention of pollution, see the Ukrainian program "All bude good."

instagram viewer