Installing ceiling moldings with their hands

original and neat transition between the wall and the ceiling is done using a special ceiling moldings (also called baguette, fillets).It may have a width of 4 to 10 cm and is selected according to the style generated indoors, room area.Made fillet of plaster or foam.The first type is difficult to set because of its fragility and considerable weight.The second type of foam (polyurethane) is more practical: the installation of ceiling moldings can easily be done by the owner of the home.

methods baguettes mountingroom

There are two variants of fastening the plinth: on wallpaper or on the final finishing (lined wall or a wall covered with paint).In the first case it is possible to avoid the subsequent unsticking of wallpaper that has not been pressed baguette.The second work is made easier due to the absence of increased requirements to accuracy of performance: the remnants of putty easier to remove with a clean wall than with curly wallpaper.

Convenient installation ceiling moldings after finishing or pre-painted walls takes a minimum of time.Therefore, it is ideal for the independent exercise.To carry out the work required to prepare any finish of high quality filler, the required number of baguettes, a pair of spatulas.You will also need the executor miter box and handsaw, by which will be cutting baseboards.

Step by step guide for installation at the ceiling plinths

First we need to prepare ourselves baguettes.It is necessary to carry out measurement of the required length skirting and spend their crop.

required to make sure that the angular joints are smooth.Therefore adapters bonded at the corners are cut obliquely, as shown in the accompanying video.After training, you are ready to spray finish putty.

She applied a thick layer on the side of the plinth, which will be adjacent to the wall and on the side that abuts the ceiling.Further carried out the installation of baguette as follows:

coated filler baseboard firmly and gently pressed against the wall and ceiling surfaces.

Narrow spatula removed spoke remnants of putty.

Held cropping neighboring plinth (the compound on the corner junction), cover it with putty, pasting, removing remnants of putty.Particular attention should be paid to the removal of the surplus in the joint.

others are prepared plinth, held their installation on the perimeter.

When installing ceiling polyurethane moldings to be completed, it is possible to prepare for the subsequent gluing wallpaper.In the case of pre-coloring the subsequent finishing of the walls is not performed.

Specific recommendations for careful handling

To install fillets in the corners of the room was carried out as carefully as possible, you need to visually assess the required cutting angle.To do this is to raise the plinth and to establish a cut-off angle is optimal.Selected indentation should be cut with a hacksaw, and prepared to make a plinth to the place of the joint with the adjacent.Overlay filler can only be obtaining competent dock (with no gaps).Using this method, mounting plinth ceiling will be performed correctly and the problems with the kind of sloppy framing will not arise.

Before installing independent baguettes should carefully read and the above instructions, and further explore the photo reports on the installation of skirting their own hands.Detailed descriptions will help you to work and to completely eliminate the problem of uneven or sloppy gluing fillets without difficulty.And the use of high-quality fillings and baguettes will perform the correct finishing room, which will keep the original appearance for many years.

Video self-installing ceiling moldings