How to use the hammer - the main study its ability to

Summary characteristics punch

Hammers have three main functions: Drilling without hammering, hammer drilling (drilling), shtroblenie (jackhammer).Its main task - drilling.They can work on almost all surfaces: stone, concrete, brick, ceramics, metal, foam, wood, plastic, etc.

For use drills, chisels, spades, drills.A chuck for the shank SDS-Plus or SDS-Max , whichever punch - consumer and professional.First designed for drills with diameter of 14 mm, and the second - on the diameters of more than 14 mm.

they are chosen depending on the hole diameter and surface.There are drills for ceramics, wood, brick, etc.To know how to work puncher, offer further study the work of its main functions, how to use them.

Drilling and shtroblenie puncher

drilling function.Before drilling hammer, it is changing the cartridge quick to SDS-Plus .Then set the required bit, which should correspond to the type of material that you want to drill.Next, put the tool rotation mode.In this mode, generally drill works.

number of revolutions during operation can be changed - it depends on pulling the trigger, the stronger you harvest, the more the drill rotation.With this mode of making holes of different diameter and depth.The work should start with a low speed, gradually increasing it.Furthermore, this mode can press the tool bit during operation, but do not go overboard.

function shtrobleniya .The chuck is clamped chisel.Then he adjusted the direction of a chisel, that is, the angle at which it will be convenient to work with.After installation, the angle a special lever is necessary to fix its position.The tool is then converted into shtroblenie punch mode.

If clean, such as tiles, then you need to put an end to a chisel between the tiles in their seam.Gradually increasing the impact speed, Stroebe tiles from the edge to the center.Normally this function is used to create channels for cable or dismantling of tiles.

Such work is carried out with a chisel or peaks.The impact velocity is not necessary to put before Stroebe puncher.This is done during operation.The degree of pressing the trigger depends on the number of strokes.Also, this function is used to create hollows in the surface of the concrete.The cartridge is installed with a wide spatula peak and angle are well secured.

drilling and screwdriving also by virtue of this device

drilling function.The cartridge is put the drill and hammer drill is converted into the desired mode.Power tool affects its performance.If it is high, then drill holes faster.The speed is gradually increased to the maximum number of revolutions.In this mode, it is desirable to lubricate the drill bit shank before inserting into the chuck.

Another function, which have tri-mode punchers - tightening screws .That is, it can be used as a screwdriver.In the hammer is put keyless chuck.It screw is clamped, and a tool set without impact drilling mode.

With reverse exhibited the required direction of rotation as well as the lowest speed.Tool put perpendicular to the surface and screwed into screw it at low speed.We should not apply pressure to the punch.

How to work puncher now known, but it is worth remembering a few rules:

• impossible to begin drilling at a very high speed, otherwise the drill bit can come off the marking space;
• can not press hard with the hammer in shtrobleniya mode and drilling;
• can not be used for a long time without impact drilling mode, so it is sometimes advisable to rearrange the rotation mode to the internal lubricant is distributed evenly.