Tile for the foundation - decorate foot home is practical

Features material

tiles for foundation is a durable material, which does not require additional costs to finish in the future.The most suitable material for the cladding is considered clinker tiles.

Its basis is clay, which is treated in the firing furnace at a high temperature of about 1100-1250 degrees Celsius.The technology resembles the brick kilns of ceramics.The thickness of the tile varies from 8 to 17 mm, and width and length are different, so the tile can have a standard size bricks or be small, mosaic-like.

This cladding tiles foundation has good frost resistance, excellent durability and minimal water absorption, it does not disintegrate under the influence of wind, sunlight, moisture and frost.Its shape helps make the masonry up to two meters high.just two problems are solved Due to these properties - the beauty and reliability.

Preparing for tiling

Substrate Preparation is no different from preparing for any other material.Cap should be smooth and free from dirt and dust, to glue adhesion between the base and tiles to be most effective.To water absorption wall became smaller and the materials did not take water from the solution, it is necessary to treat the surface composition of the soil.

If not novovystroenny base and is coated in a plaster, it must be removed.It is convenient to use a hammer and chisel.

deviations on the surface should not exceed 4 mm.If they are still more than this figure, if you want to apply by spraying the mixture for leveling.

To find out the number of stacking levels, height of the foundation should be divided by the width of the tiles, but do not overlook the width of the seam between the rows.To number of the entire length of the cap was on the same level, you need to beat as a starting strip steel profile or a long rail.

foundation Facing tiles - how to do it?

When the surface is ready, you can mix the tile adhesive.To work you need poluter with serrated side.The adhesive is diluted according to the instructions, otherwise the solution will turn a bad consistency and last a long time.

Then evenly apply glue mixture onto the wall.Then you need to spend it on the flat side polutera and then notched.The layer of glue on the wall must remain no more than 4 mm.Since the quick-drying glue, it is necessary to spend for 30 minutes.

It is very important that the solution was applied uniformly, because voids can be filled with water and freeze in winter.Because of this, they expand, causing that tile starts to fall off.Therefore, the adhesive mixture is better to put on the tiles and the wall, then the blank space will definitely be absent.

laying tile should be started from the outer corner.For vertical seams do not coincide, each row must move at half length of the tile, it must be pressed into the solution and inserted into the seams crosses.With their help it is convenient to observe the desired seam width.

When tiles for decoration foundation can settle and the solution dries, you can overwrite the seams.To do this, use a rubber spatula.Grout should be elastic and frost.Concreting solution is applied diagonally relative to the seam.After drying, the tile should be cleaned with warm water.