Workbench with their hands

in any private home, the workshop or garage Workbench is very necessary subject.Using it is convenient to make or repair any thing, as it combines the functions of the table and shelves for tools simultaneously.It is possible to equip the bench screw, and set him grinding machine for various tools.If you purchase a metal workbench in the shop, it will cost a considerable sum of money, but it can be made from wood bench with his hands.

Required tools and materials

So, for self-production work bench in the garage neededthe following tools:

• hacksaw or electric jigsaw;
• Roulette;
• Elbow;
• Building level;
• wrenches;
• Drill;
• screwdriver.

Materials:

• bars for supports;
• 2 plywood or OSB sheets (one of the sheets is cut under the shelf proper size);
• boards for the frame;
• screws;
• bolts;
• washers;
• nuts.

work needs to be done before the bench dimensioned drawing for assembly convenience.

Step by step instructions for the manufacture of bench

To manufacture the upper frame is necessary to saw off the board on the basis of the required size workbench (see. Photo).

Using screws to fix 2 long and 2 short board, so as to have a rectangular frame.When using a tape measure to note the distance to the middle of the frame, and perpendicular to, between two long boards to fix the remaining short board, attaching it with screws at both ends.

For making legs bench need to cut off 6 equal bars.On the inner side of the base obtained in each corner of the frame to fix on one leg using bolts, washers and nuts (see. Workbench scheme).

For stiffening structures necessary to put extra board, which also will serve as the basis for the bottom shelf.To do this, cut off 4 boards.

Roulette is necessary to measure out equal distance from each leg to 30 cm, the resulting level to fix the board to the rear of the buildings to the 3 legs, and the front part to fix the board between the extreme and the average foot, in the place where the future of the regiment planned.

remaining two boards should be fixed to the legs, at the same level, as well as boards for shelves.

of one or more sheets of plywood or OSB using a hacksaw or electric jigsaw Scrollsaw necessary segments.Attach them to the top of the bench flush with self-tapping screws.Additionally, the top can be attached sheet of hardboard, becauseit can be easily exchanged for a new one if the old is very old.For this scheme is and the lower shelf.Roulette is measured by the distance between the outer and middle legs of the bench, on the size of the list is sawed material and is mounted on the resulting substrate.

When attaching the legs or cross members must use a square to obtain an equal distance between the parts of the buildings.With the help of level, place of installation, you need to check exactly whether the workbench is made with their own hands.In the case of deviation it is necessary to align the way stands for legs bench wood chips.

Bench of wood can be covered with a special protective structure.In its left half near the shelf, like the picture, resulting in a niche you can put the toolbox.

video look for greater clarity on how to do table-bench with his hands.

Video manufacturing bench with his hands