How to make the screen under the bath of plasterboard with their hands

completing repairs in the bathroom and installation of all plumbing devices.This work is uncomplicated and accessible to almost everyone.To avoid unnecessary expenditure on professional challenge, see our recommendations for screen manufacture of plasterboard with their hands.

This screen design - team, then you should start with the skeleton.For its production need segments of the wooden beams, 40x40, fasteners, consisting of screws and metal parts.The bars must be put to the corners of baths and attached with screws to the wall.

makes the screen under the bath of plasterboard.

1 stage. Start necessary with the markup.

Stage 2. On the wall mark the line, it must be from one of the corners of the bath to the floor.

Stage 3. At a distance of 2.5 cm from the line drawn by draw a new line, parallel to the original.The new line should be turned into a bathroom.With a plumb line to vystupayuschnmu corner bath, note the point on the floor.

Stage 4. From this point on the floor should traced out square inwardly bath.square size of 2.5 by 2.5 cm.

5 stage. from turning on the bath corner, painted on the floor of the square, in the direction of the lines on the walls hold on the same line.

6 stage. now need to prepare for the frame bars of prepared for this timber.Bars should be in the following sizes:

- for the frame must be 4 vertical bar of the same length equal to the distance from the lower rim to the bathroom floor;

- for a short horizontal bar 2 is necessary.The length should be equal to a line drawn on the floor parallel to the short side of the bath and minus 80 mm (we must take into account the width of the double bar);

- for the calculation of the long horizontal line is similar, but subtract 120 mm, consider a triple thickness of the bar in the further assembly.

Now we can start assembling the screen itself under the bath.

Putting a frame for a short bath side.

1) take 4 short bar and connect them with metal corners with screws;

Widget from SocialMart

2) in the bar, which will need to be anchored to the wall, it is necessary to drill two holes;

3) Now you need to attach the frame with a small side of the wall, and the hardware (screws, screws, dowels) must be selected depending on the type of wall (concrete, brick, block, etc.);

4) long frame assembly is carried out similar to the previous one.Now, with your hands need to connect the frame together with screws and screwdriver.

Helpful hints: To make the design of the screen under the bath of plasterboard greater rigidity is not superfluous to attach it to the bathroom floor.

We produce panels of plasterboard for the screen under the bath.

material that will be needed for the manufacture of both display panels for bath - drywall with moisture resistant properties.Typically, it is dyed a light green color.Also, we will need a metal latch and padlock hanging loops for securing manhole door.

Next, we need to make the marks on the drywall sheet.It is convenient to use directly the major and minor panels next screen.Dimensions are small size of the corresponding (lower) frame, and the length of the second panel is larger than the frame at 56 mm, 40 of which - the width of the bar, and another 16 - the thickness of the small panels of drywall.

After marking performed, it is necessary to cut off parts of the planned building with a sharp knife.

Immediately before installing more panels to the frame itself do not forget to make a hole square shape - your inspection hatch.The length, width and location of it will depend on the tile size (which is sure to decorate your handmade work).For cutting out of the holes, you can use an electric jigsaw.Important: The flap should be in front of the drain pipe and the ramp.Now you can proceed to the final assembly.To hang on the door hinges and fasten the latch.

final touch: combine both the screen under the bath panel of drywall with screws.Connect the panel must be strictly at a right angle with respect to each other.

And you can now test the screen design for the bathroom of the drywall on the mechanical stability.

to your brand new screen under the bath of drywall made with his own hands looked original and perfectly combined with the design of the bathroom, you can make the lining of ceramic tiles.See below for related articles.

Especially for site Self Repair apartments from A to Z.