In some places it is possible to cut the tape ICE ?

So in fact there is nothing complicated about to cut a piece of wire.As a rule, the place designated by the manufacturer of cut every 3 LEDs (see step 5-10), which is clearly seen in the picture below:

All you need to do - take a sharp pair of scissors and have clearly marked on the line.Be careful and strictly on the cut line, that we do not damage the LED Strip.

draw your attention to the fact that LEDs are only necessary to cut in a disabled state!Working under tension as shown below in the video, not recommended sinceif you accidentally provoke a short circuit, and can burn the tape, and the power supply!

correctly cut LED conductor follows:

also want to give to your photos, which show might look like the place of the cut LED tapes from different manufacturers (eg, Jazzway or Apeyron):

should alsonote that sometimes manufacturers do not mark a line on which you want to cut, scissors icon.In this case, you need to cut the material, setting the scissors blade Mezhuyev two pairs of neighboring access points, as shown in the very first picture in the paper.

That's all that I wanted to tell you how to cut the LED strip.We hope that now you know, after some distance, you can do cut and how to do it correctly, so as not to damage the power supply!