Build Daily

Protection

August 12, 2017 18:07

Laying of antistatic linoleum requires careful work

click fraud protection

Why you may need an antistatic laying linoleum?

begin acquaintance with an antistatic coating, which previously you would not pay attention, and now you have to think through the process of installation.This type of linoleum, of course, is unlikely to be used at home, because there is no such accumulation of static electricity.That is why most markets can be seen commercial linoleum, an antistatic effect which is important to the company, where we are actively working with electricity.This may be the electronics manufacturing company or a server.

his secret is that in its composition has a linoleum carbon fiber or just adding carbon powder, depending on the type.Types There are at least three, they differ to their resistance.The greatest resistance is antistatic, average values ​​have tokorasseivayuschy, the smallest resistance shows conductive.All these indicators are measured periodically with special equipment that the coating retained its main purpose.

Laying anti-static linoleum requires special attention

Since the conductivity of the coating is not universal in any of its position, the special requirements for the thickness of the linoleum and the quality of its styling.Even the moisture so affects the conductivity and the ability to evenly distribute electrical voltage as thickness and surface quality, because, for example, in areas of different thickness is different resistance.Also these parameters affects the quality of the surface to which the material laying antistatic linoleum.

In preparing the surface it is important to ensure contact coating earth (ground), for this there is a special copper belt for laying anti-static linoleum is also important to the quality and method of preparing the adhesive.Pre-coated sheets laid on a flat surface so that they become accustomed to the new location.It should also be said that the room should not be cold during stacking, but not hot, about 18 degrees, and the humidity does not exceed 60%.When laying the watch carefully, so that the coating has not been bought by folds or kinks, then it can cause problems.

Getting laid antistatic linoleum

First position in accordance with the plan of the premises of copper tape.They should be placed along each seam linoleum sheets at a distance from the edge of about 20 cm. Across flooring copper strips are arranged, which strips are connected to, and then to the grounding system.

Next, prepare the glue, special, conductive.His purchase with linoleum, in consultation with the seller to choose the right most part.The adhesive should maintain its electrical properties over time, so that the coating does not have to perestilat.Carefully read the instructions to find out the time of drying and the amount of consumption.Gluing need for fresh glue, when he stood for, the quality is significantly reduced, which can cause uneven coating, and it is not desirable for antistatic linoleum.

adhesive is applied over the copper plates with a film mode with it is better to specify in the instructions.Find out when you can lay cover, wait for the right time or immediately imposes Linoleum.Now it is important to ensure full contact and expel air bubbles.To do this often use a special ice rink, which is rolled coverage in all directions until the adhesive dries.

Sometimes after gluing coverage to do it cuts, it should be done very carefully so as not to get on a copper grid under the linoleum.

instagram viewer