Build Daily

Fences

August 12, 2017 18:05

The gate made ​​of wood with their hands

click fraud protection

wooden gate leads to the entrance to the yard neat and further protect private property from intrusion.Robust design is most easily made from planks and beams.In addition to the work required small metal corners, bolts.

Content

  1. Tools
  2. Materials
  3. Preparations
  4. main stages of assembly
  5. Production upper ceiling and installing latch
  6. Video installation gates made of wood with their hands

Tools

  • level;
  • drill with bits;
  • Roulette;
  • Elbow;
  • Building a pencil;
  • Ratchet with socket head.

Materials

  • wooden bars;
  • Metal corners;
  • hinges;
  • Bolts;
  • Self.

Preparations

gate is made of wooden planks, the frame is assembled from timber.Put in the frame will be on-boards support that the executor is obliged to install it into the ground using metal wedges, supports.

They should be placed at such a distance that the owner did not have to cut the boards for the gate.

Therefore, initially to be measured pass to calculate a number of boards required for the door.

at a fixed distance to the ground mounted support.

Main stages

assembly First you need to prepare a framework that will be the basis for the wicket.Its height should be 5-10 cm less than the height of the boards.This will fix them firmly without deteriorating the appearance of the structure.

assembly is made by means of narrow metal parts and hardware.

should pick up screws, which in diameter is much smaller than the width of the timber used for the frame assembly.

Otherwise the probability of damage to the material.In the center of the rectangle collected additionally mounted cross bar.It will strengthen the design and distribute the load correctly.

Next job is to direct mounting frame and nailing it to the boards.It will help to understand how to make a wooden gate with their hands the following statement:

1. It supports scales pillars dug earlier tried on a prepared frame.

2. The frame is firmly set in the opening (used as a backup in the photo).

3. On-bars supports are mounted hinge (screws need not tighten fully) pre-exposed for the entire level design.

4. Mounts regulated and until it stops running out.

5. To frame screwed on the screws previously harvested board.They need to be placed close to each other, to avoid the appearance of unsightly gaps.

These steps will make a wooden gate, which in the future owner can paint.It is advisable before using the boards and beams to conduct impregnation antiseptic materials.This will protect the wood from soaking or drying.In addition, the composition helps to prevent damage to tree pests and avoiding the formation of mold on the fibers.

Fabrication and installation of the upper limit of the latch

cmontirovannaya to the gate of the tree looked really attractive, it is recommended to make the top of the opening frame.For convenience, the strip should be placed not at the top of the boards, and slightly higher.To do this, between the top of the support bar and the most you can put a small piece of board or timber.Cobble together the best elements of long nails (4-5 pieces).This will reliably fix complement.

An equally important element of a wooden gate and a small door will lock.It must be placed on the board at the gate (with opening side).You can use a small metal accessories: it is well designed and will complement the tightly closed door.

All these recommendations and tips will help each owner of a private house or garden to supplement the previously mounted neat wicket fence made of wood.Before the work it is recommended to study the accompanying photos and video tutorials.The duration of the work will take 3-4 hours.A simple element connection scheme allows to make such arrangement of his own yard to any host.

installation Video wicket of wood with their hands

instagram viewer