Thermal insulation of plastic windows

Many people, setting in a private home or apartment has plastic windows, consider that the problem with the insulation space is solved for many years, and therefore forget to not only take care of the windows, but do not check whether allwith them in order.Therefore, they appear in the microcracks and requires insulation of plastic windows, which can be done independently.

Why is there a problem with plastic windows?

most often insulation plastic windows in the winter may be required for several reasons.Very often over time, any home can make shrinkage, and in those places where such windows are installed, there may be a small gap.Most often this phenomenon occurs with the new buildings.In this case it is necessary to make insulation slopes of plastic windows to get rid of these cracks.

microcracks can also appear due to drying of the sealing rubber profile at the point where the leaf attached to the frame.This is due to the fact that the windows not being proper care.If there are such microcracks, it is possible to make insulation plastic windows with their hands by replacing the rubber profile.Over time, this profile can lose its elasticity, thinned or wipe.To microcracks did not increase, it should be possible to change the rubber profile more quickly.

How to insulate plastic window with his hands?

If sealing gum dries out, some people try to make the repair and insulation of plastic windows by dry lubricating rubber with silicone grease.But in fact, it will not give a positive effect.To get rid of the microcracks, it is necessary to change the rubber seal on the newer, and the window will be tight again.In this article, there is a photo of insulation of plastic windows, and shown where the sealing rubber is.And if familiar with video insulation plastic windows, the whole process of the new seal can be seen from beginning to end.

To resume the sealing of windows, contact the service center for their service or directly on the manufacturer and need to buy them a new sealing gum.But it is necessary to specify, for what it is necessary profile, as each model uses a different profile, and therefore may differ gum.It is very important to the plastic insulation of windows outside, not only from the inside.It is necessary to remove the old sealing gum and change it to a new one.

Leakage can occur in the case where the faint eccentric closing fittings.If this happens, it is necessary to adjust the window with eccentrics which are mounted on the end flaps.It's very simple to do using an Allen key 4 mm.It is necessary to gradually rotate the cams and at every turn to check how the window is closed, tight or not.

Sometimes depressurization is not because of problems with windows, and due to improperly exposed slopes.In this case it is necessary to make the outer insulation of the slopes of plastic windows or alter them.It may appear a small gap at the junction of the window and the sill.From the outside it does not turn well to seal the crack in the winter time.But it is possible to establish a temporary protection by means of the mounting tape, and when the spring comes, then the outer side of this gap will need to close up more carefully.