Adjusting the plastic windows with their hands

Replacement of glass - one of the primary stages of repair.However, the installation of plastic windows necessarily implies the subsequent treatment, such as self-regulation of plastic windows in winter or minor repair of plastic windows with their hands.There is not much potential damage plastic windows, and repair methods are simple enough.

Adjusting plastic windows pressing

The most common adjustment involves adjustment of plastic windows pressing plastic windows, namely the adjustment of the winter and summer.It is clear that in the winter clamp window sashes should be stronger in order to avoid drafts and summer nip roll off.

First, you need to make sure that the adjustment of plastic windows is necessary.You can use a lighted window in a closed match or lighter - if there is a draft, the flame zakolebletsya or even extinguished.So you

determine the density of the pressing .If the adjustment of the pressing need of the plastic window have to do some simple manipulations.

When you open the window note on his butt .There you will find three eccentric regulating clamp plastic windows, also called pins.Using a hexagon, cams can be turned on video shows how to do it correctly.

for tighter clamping turn them a few millimeters to the left to loosen clamp - to the right.The work is very simple, and you will generate easy adjustment of plastic windows independently.The main thing - make sure that the pressing density was uniform, and for that the cams should be necessarily exposed to the same.

It is worth paying attention to the considerable nuance Pressure Adjustment plastic windows - for the first time to make minimum adjustments, since the sealing rubber bands on the leaf shrivel with time and wear, and therefore the adjustment will have to start over again.If you immediately press firmly flap gum ssohnutsya faster, then no adjustment will not help and the need to change the sealing tape.

This too is no big deal.Old gum is simply removed and a new set in a groove.The only thing to be careful, because it is so, so as not to stretch it too much, otherwise it will leak air.

adjustment knob plastic window

you were in a situation where window handle broke , and the window does not close.This is just one of the most common variants of the repair of plastic windows with their hands.

Firstly, you will need to purchase a new pen - they are sold in any construction market and any manufacturer sells accessories for plastic windows.Secondly, you need to remove a decorative panel covering the fasteners handle to the window.To do this, simply rotate it in any direction, and then simply remove the screws that hold the handle of the old, and they also screw the new one.

adjustment fitting plastic windows

If the window does not close because of-the fact that the handle does not turn , you will also be able to carry out the repair of plastic windows independently.The problem here is that the turning handle fixed lock handle when the window is opened.These bollards installed almost all the manufacturers of plastic windows, in order to avoid damage handle themselves.In this case, the adjustment fitting plastic window is quite simple.

Notice what is written on the constipation.If there is an inscription AUBI , then you need to send the flap vertically, and then push down the metal plate with the spring and turn the knob to the desired position.

If constipation is written on GU, ROTO or other letters, you need to adjust the metal tab just under the handle - push it and turn parallel gasket.

Video adjustment plastic windows with their hands

For greater clarity, we suggest you watch the video adjustment plastic window.

We bring you another video instructions that help you adjust the plastic window for the winter and the summer.

fittings Adjustment:

When not helping with the adjustment of slack:

Remedy blowing from under the gum:

When the window handle is not closed until the end: