Build Daily

Fences

August 12, 2017 18:05

A fence made ​​of profiled sheet with his hands on an uneven area

click fraud protection

fence profiled iron has become in many cases no alternative installation method opaque fences of private zones and areas.It is easy to install, economical, it can be installed in the home.The review deals with one problematic issue of how to make the fence of trapezoidal sheet with his hands on an uneven site.

Content

  1. marking sites and sampling plan on an uneven plot
  2. foundation for a fence
  3. perform hardware
  4. Photo fences made of profiled sheet on the side of

Choice sheeting is quite objective,since a sufficiently low price, rapid installation trapezoidal sheet provides the desired mechanical reliability fence and gorgeous aesthetic qualities.The enclosure is available in a variety of colors, you can choose to RAL.

marking sites and sampling plan on an uneven plot

usually begins with the installation of the fence rigid planning framework - the columns that will hold the iron sheets.The bars are set equidistant from each other.The most common fence height of 2 meters, the columns are selected 3 meters high, spans between the posts are usually made on the length of profiled sheet - 2.5 meters.To be safe, use a metal pole with a size of 60 x 60 mm, as well as cross-joists 40 * 20 mm.

fence of corrugated board with your hands on an uneven portion recommended on the foundation of the "ladder", which is firmly fixed metal poles - two for each flight.It is saved and the length of the span - 2.5 m, provided the average slope of the site - up to 30-35 degrees.A larger deviation spans make shorter length to reduce the drop step.

foundation for a fence

on the slope of a fence from metal sheets is done so that each indentation down the flight of the same.For this purpose, you need to properly calculate the height of the foundation on each span.Provided that the plot slope greater than 30 degrees or is uneven slope can be made on site "landscape step" with flat planes, which also strengthened the foundation.In this case, the design spans the length is held in conjunction with landscape planning.

height of the foundation must be maintained so that the descending ladder upper indentation was uniform, it is necessary to preserve the aesthetics of the barrier.Nearby bars are installed close to each other.In some cases, it may be changing the span, the requirements dictated by expediency and personal preferences.Boring holes for poles is recommended at a depth of soil freezing, ie,1-1.5 m.

perform hardware

fence made of profiled sheet with his hands fastened to the final based on an uneven plot is similar, like fencing, performed in a single line.Since the steel sheet is used for the roof, it should be noted that the sheets are applied with the depth of waves up to 20 mm for the fences.This is enough to store the high mechanical rigidity of the fence.

When attaching the metal sheets need to be as accurate as a scratch, not only do the fence not aesthetic, but also become a cause of corrosion.For fasteners are used for roofing screws with rubber pads under the color of profiled sheet.Mounting screw is carried out in one step, that is, it does not require drilling a hole.When using rivets require pre-drilling.Mounting studs are often used in suburban areas, to prevent theft of the fence and the outer fence at the same reason.

Installation sheets produced if necessary overlap "wave in the wave", respectively, this mounting method requires an increase in the flow sheet.From the ground or foundation leave a distance of 10-15 cm for good ventilation area.

After installing the protective caps at the poles and end brackets made of profiled sheet fence with their hands on a site with a slope can be considered complete.

Photo fences made of profiled sheet on the side of

See photos Fences made of profiled sheet, built on the slope:

instagram viewer