How to display tracks and stages heating cable ?

What benefits?

heating cable open spaces have long been used by most offices, shops and shopping malls, which is important reputation.The advantage of laying of floor heating on the street is this:

• surface is clean and dry throughout the day.
• tile, asphalt or natural stone will not be damaged by mechanical cleaning with shovels or even worse - a crowbar.
• absence of injury, which is especially important, even if we consider a vacation home.

As you can see, really, it makes sense to carry out the installation of tracks and stages of the heating system.The cost of laying the floor heating will not be too big, in fact, as the consumption of electricity system if to make things right.

technology

laying with his hands, as we have said before, do a warm floor in the street can be yourself, if you know the technical aspects and nuances of laying.The system design is not complicated.It includes a self heating cable, thermostat, humidity sensors and rain, the signal cable (for connection to sensors) and of the protective equipment.As for the heating power, then, as a rule, for the calculation of streets reduced to 250-300 W / m2.In this connection, it is recommended to choose the conductor capacity of about 28 W / m.

Before proceeding to the installation of floor heating, the surface must be carefully aligned.After this, according to the manufacturer's recommendations you need to perform laying of the heating conductor and its connection to the network, sensors, protective automation.Then, depending on the situation, poured concrete screed, which after curing is recommended to pour a layer of sand.At the last moment we have to move on to the paving of natural stone, tiles or other suitable material.

can also do without the tie, just slept on the warm floor sand cushion thickness of 3-4 cm. If you still need to fill the screed, certainly before this fix the heating cable outside the mounting tape, as shown in the photo below.

sensor installation locations are discussed in the enclosed instructions from the manufacturer.Sam thermostat must be installed in an area protected from the rain and low temperatures.We recommend that you install the thermostat in the hallway.

During the installation of electric underfloor heating on the street definitely keep in mind an important point - on the cable should not affect paving elements.If you miss this point, further heating of the cable platform system may be damaged.Its repair will be extremely problematic and of itself - expensive.Here we should note one more thing - if you decide to lay floor heating on a sandy base, keep in the sand was not the stones and other debris, asunder a load of stones can damage the conductor.

If you want to make an electric heater on the porch steps, the cable is laid on the chosen scheme with the same pitch over the entire area.After that, poured concrete screed on top of which carry paving stone, tile or even marble.Incidentally, an alternative heater in this case may be either termomat tape.Visually see what the heating steps in the street, you can in the diagrams and photos below:

recommend also view the video installation instructions:

That's the technology of laying floor heating on the street with his hands.As you can see, the installation of heating systems of street lanes and steps is quite time-consuming.We still recommend giving this matter experts, many of whom will do cheaply and quickly.Only in this case, the heating pad is economical, safe, and durable!

will be helpful to read:

• How do
• fence lighting How to run a cable under the ground
• How to install solar panels for home