Cover well with their hands

at their summer cottage or in the private residential sector, well - it is not only cool, clean drinking water, but also a decorative element of the site.In order to keep the water inside is not frozen, and the inside of the mine did not get the garbage and animals, set the cover on the well.

Caps are : solid or folding. Materials , most commonly used for the covers of wood, steel angles and tubes, PCB, steel sheets.

well lid must be tightly fixed on it, have a margin of safety, provide ventilation, as well as having an aesthetic appearance.Still, be sure to check the article about making the house to the well with their hands.

cover manufacturing technology wood

wooden cover for the well looks aesthetically pleasing, but it is relatively easy to do.Use of oak wood, pine, birch, aspen.Finished covers lacquered and optional further elements or decorated with carvings.

1. test is performed to create, carry crate of wooden bars, which obbivat hewn planks.In the center of the lid reinforcing nailed a piece of wood.
2. In the same way we make the top cover.
3. Install hinges or rubber strap for easy operation.One part of the belt is attached to the tvorilu, the other directly to the cover.
4. platform for the cover are made from wooden beams on the perimeter creates.

Just of hewn planks, probably to make the cover with two doors.cover halves attach two straps, hinges and handle set in the middle.

cover the well of metal parts

Required tools and materials: metal corners, Bulgarian, welding machine, shaped tubes, PCB, measuring tape, metal hinges, insulation, sealant,paint for exterior decoration.

Stages:

1. Cut corners 4 of the desired length at an angle of 45 degrees, we connect them to the square and we catch welding (on the outside of the corner and on the inside).We clean weld grinder.Check the frame is correct by measuring the diagonals.
2. Cut profile pipes, laid inside the frame (on the perimeter and cross - wise) and we catch welding.Stitches we clean the grinder.
3. From PCB cut out the plate on the frame size, fasten them with screws.Between the layers of the PCB is required to add a heater, and the seams be sealed.
4. Attach the cover to the frame with metal hinges (they are fixed or bolted or welded).
5. Then do the formwork and fill it with concrete (cement).Attach to the mold frame with a lid.Fill the concrete.
6. To hatch bolted handle, paint or decorate the surface.

Benefits manufacturing hatch covers for the hands - unique design, low cost, the ability to pick up the necessary insulation.In the manufacture of caps for the well to be well aware of the protection of children and animals, and, therefore, install locks or special houses.