Polymer putty - chemistry on home aesthetics service

polymer coating - the first acquaintance

ultimate goal of any repair is the finishing room.Pasting the walls of wallpaper or paint them usually bring a festive mood.The room in front is beginning to take a finished look, and so want as soon as possible to install furniture and start to settle in and decorate it.But it would be desirable to speed up all repair and construction work, neglect or ignore some finishing stages should not be.

walls in your home may seem at first glance, quite smooth, so some finishing work simply omitted, but it is not.Always on the surface of the walls and ceilings there the slightest bulge, cracks, joints and cavities, which do not allow to achieve the perfect end result.For surface smoothing, and also for sealing cracks and joints, various fillers are used in the repair work.

decisive importance when choosing a filler binder.Depending on the component fillers are divided into cement, plaster and resin.Plaster and cement putty for quite a long time on the market of building materials, their properties and characteristics are fairly well known.

Putty polymer - a relatively new building material that is widely acrylic and latex fillers .

Acrylic Putty is used for both internal and for facade repair and construction works.A distinctive feature of this species is the versatility and simplicity of operation.It is used for roughing, leveling, and for finishing. Latex putty usually used for carrying out internal repairs.These fillers are odorless, have a high ductility, durability and impact resistance.

putty polymer - the scope of the

When choosing fillings must be read carefully to the scope of its application.Fillers are: alignment, special, finishing and universal.First, as the name implies, are used for the rough surface treatment, its alignment.Special used for clearly limited purposes, which have special ingredients in its composition.

polymer finish coat is applied to the blister layer for the purpose of embedding the micro-cracks and to obtain a perfect surface finishing.Universal fillers are also suitable for leveling and finishing of the surface is prepared.

Using this type of fillings in carrying out repair work always gives a good result.This putty is applied on cement, plaster, concrete, plaster surfaces, as well as a filler for polyurethane.This material is very ductile and easy to use, helping to reduce fuel consumption, as well as labor costs.

Through the use of this material, to prepare the surface is perfectly flat and smooth.This coating does not crack or shrink, quickly grasped.The distinguishing feature is the duration of its storage in a finished form, in a closed container, it can be stored up to 12 hours.

As a rule, this type of material used in the finishing of ceilings and walls.The only drawback is the price.

How to work with the resin filler?

Apply polymeric filler is necessary to pre-prepared base.All dirt, dust, old plaster, grease stains to remove.The surface finish must be covered by a mineral primer.

dry mixture of polymer fillings need to pour into a container with water and mix thoroughly by hand or with an electric beater "mixer".Thereafter, the material is left for 10 minutes, then mixed again.

polymer coating applied to the surface with a trowel or a trowel, not exceeding 3 mm.Technology is as follows: a small trowel is taken of the putty is applied to the solution and a wide putty knife edge, then this trowel applied to the leveling surface at an acute angle, and the entire putty thinly spread on the ground.

Approximately 4 hours after the drying of the material necessary to level the surface by treating its construction grater or sandpaper.Movement on the surface must be without pressure, circular.If to give the surface a perfect smoothness of one layer is not enough, you can apply a second layer of putty, but not earlier than 4 hours after the drying of the 1st layer.