How to seal the seams on the ceiling

necessary materials

1. spatulas
2. powdered plaster of gypsum
3. polyvinyl acetate glue
4. Masking tape
5. Brush
6. primer solution
7. abrasive sandpaper

seam Installation in ceiling: preparation

seam between the floor slabs smooth out with a spatula or a drill with a special nozzle, damaged and unusable areas cementation carefully scraped off, freeing the joint of debris and small particles.

overlapping joining surface is cleaned from dust and then the primer solution diluted according to the manufacturer's instructions.Then, paying attention to the width of the seam, you need to choose the right brush, which will be primed.It should be of sufficient width and length of the pile should allow the solution to penetrate deep into the crack or joint to provide adhesion to the plaster surface.After the primer dried seam.

Prepare plaster and using the

dry plaster powder is stirred with the instructions specified in the water, and the mixture is stirred until smooth using a mixer construction.To prepare a small amount of plaster, you can use a spatula.

prepare the masses need to seal the cracks and voids, in the case of a large depth of the gap is better to put the solution several times before prosushivaya dryness each previous layer.When too large gaps between the plates and filled with foam, then remove the excess and cause gypsum plaster on top of it.

final stage of the closing of cracks

After the final drying plaster all patched surface smeared with glue PVA and then glued masking tape, forming a gap.On top of it should be applied layer of putty, which after drying is leveled and sanded fine-grained sandpaper.

decorating drywall seams

Gypsum ceiling designs are simple to install and widespread due to the fact that one can create ceilings of any configuration.Gypsum plasterboard is made of gypsum, which is a property of expansion at different humidity, so the joints of sheets are formed cracks.For their decoration is necessary to prepare everything necessary at the stage of repair.

necessary materials

1. Cutter
2. Brush
3. Spatula
4. primer solution
5. Caulking
6. serpyanku

Preparations for decoration

seam extending between the gypsum paintings embroider -chamfer cutter cut off, simulating the factory.To do this, cut the drywall edge and slightly deepen the seams.Thereafter, the prepared surface of the seam and cleaned of dust residues cardboard.

primer solution was prepared in accordance with the manufacturer's recommendations.For rooms with high humidity should choose a waterproof undercoat.Impregnating the brush thoroughly applied to the whole surface of the joint, after which it is dried.

embedding seams

To work necessary to prepare putty for sealing the joint - it is suitable as a ready latex putty, which is perfectly suited for these purposes, as well as the usual finishing mixture.When cooking putty should remember that for quality work the mixture should be smooth, without lumps.Using a spatula need to collect the necessary amount of mass to furnish and cover up its seams.

Then you need to measure a certain length serpyanku, which is then glued on top of the raw putty.Trowel leveled surface of the weld, and then you must wait until dry mixture.

final stage are finishing work - sandpaper need to clean up all the joints, and then brush soaked in primer fluff all plastered surfaces, ensuring the greatest possible smoothness.This kind of work will be under the force of every layman, because the presence of special skills are required.