Repair formwork for its successful operation

Sturdy construction - a solid foundation

Create formwork - is one of the most important processes in the construction of the foundation.boards or plywood is used for its construction.Mounted reinforcing strut, and than their pitch will be lower, the more reliable will be the whole structure.They assembled boards, which are mounted outside the backups in increments of 50 cm, and the struts are mounted inside.It should be noted that they must be used even when the assembly of metal constructions, as without them, crush concrete formwork.

Note!Attach spacers necessary with the help of powerful nails or wood screws for metal.To

system more reliable, it is necessary to know how to reinforce the formwork.To do this armature is placed at the bottom section 12 millimeters.From it you can make the frame.To do this, wire binds several bars of reinforcement.This framework is set in a trench on the bricks that are put on edge.This framework is needed to protect the foundation from the strains and increasing its resistance to ground shifts and changes in temperature.In organizing this arrangement is much less risk of breakage and, consequently, the need for repair.

Eyes and repair formwork

By reinforcing the formwork, check its flatness.It must have angles of 90 degrees, and straight walls.This factor is of great importance, because the rough surface will create uneven pressure, and clean the building will not look symmetrical appearance.If you find a problem, you need to know how to align the formwork.Make it easy enough.If there is an indentation or bulging in the design, the correct reference pegs, hammer them closer or farther away.If the matter is uneven boards, replace them.In case of violation of verticality and correct pins.

Separately need to say about the formwork repair.Before pouring the concrete carefully check it for damage.If there is a board cracked, replace them, otherwise they will break, and the fresh concrete is spilled over the boundaries of design.Also check out the castle all the support pins, they should be sturdy and durable to be driven into the ground.Special attention is given to check connections in the corners, if there are doubts about the strength, take all measures to strengthen them.

Important!To pegs hammered deemed reliable, deepen them by at least 15 centimeters into the ground.

basement waterproofing

Before you start pouring concrete should be done waterproofing.Waterproofing of the formwork can be done in several ways:

• Laying evroruberoida;
• Laying waterproofing of getting action.

First, consider the variant without waterproofing.In this case, the foundation will occur fungus, mold, the walls are wet, that is bad for health.This embodiment, of course, unacceptable.The second way - is laying evroruberoida.It puts it at the bottom of the trench before filling.Once the foundation is ready, it is also smeared with resin and roofing material.This method is the most popular because of cheap, but it is not the most effective.

The third way is to use a waterproofing of getting action.This method is more expensive, but it guarantees reliable protection from moisture for many years.Such waterproofing is added to the concrete during its preparation and making protection from moisture from the inside.Experts believe this method is the most reliable.

Note! big advantage of penetrating insulation is the absence of seams through which sooner or later will begin to seep moisture.