Pile - strip foundation - now you can do it with their own hands

Strip foundation with piles - give an assessment

This type of foundation is suitable for the erection of structures on soft soils, such as peat soils or marshy terrain, ie, it is used when a layer of incompressible soil is at a depth, not suitable for othertype of foundation.

By advantages include the ability to use it in areas with a strong bias and weak soil.A relatively small number of necessary materials and their low cost is also emit this type of foundation among others.With his device, you can use a concrete mix, prepared independently.

Strip foundation with piles has its disadvantages .Firstly, its arrangement requires complex calculations.Error in them is costly, because the building can simply crack.Secondly, it is impossible to lay a foundation for buildings with heavy walls and a large total weight.Third, technology is the foundation of this device does not create any basement or ground floor.

pile-strip foundation - the variety of designs

This building element has several varieties: strip foundation on screw piles and bored.Screw pile - a metal tube with a screw thread blades.In fact, it is a huge screw, which is screwed into the ground.

Due to the screw thread increases the stiffness of the support area and fixing in the ground.Screw in a pile can be like using special equipment or manually.Before installation, it is necessary to carefully paint to extend its life.

Strip foundation on bored piles require a drilled well.The concrete is poured directly into the well when the ground is hard and does not crumble.If the well has been drilled in the granular soil or soil with high humidity, it is necessary to carry out its cased.

For this fit asbestos-cement, steel or cardboard tube, which in combination will be playing the role of waterproofing.It is inserted into the hole, and it is already filled with concrete.This type of foundation is most suitable for the construction of their own.

Strip foundation on stilts - how to make yourself such a structure?

Equipping pile-strip foundation with his hands , more appropriate to use a circular cross-section of the pile, as with a normal construction drill can make a round hole.rectangular poles will require the mobilization of specialized equipment.

wells drilled as the tape corners and along the perimeter at a distance of 1.5-2 m from each other.The depth of the wells may be from 1.5 to 3 m. The role of cushion sand can not be overstated, since it protects the entire structure from mechanical impact.Sand bed height of 30 cm is filled under each pile.

Thereafter, both sides of the tape should be set timbering.It must be like to be strengthened so that it is not squeezed poured concrete mixture.After shuttering device should perform a full reinforcement piles and tape in a single structure.Rods fittings as possible should be solid.They are tied to each other or welded wire.

After reinforcement can be poured continuous footing on piles.First, poured themselves a pile, and then the tape, and must undergo as little time as possible between these procedures.For a device of such a foundation must be approached with the utmost seriousness, as a non-professional approach to this work will bring only losses.