Heat-resistant varnish - protects the wood properly

Features refractory varnish

Under the influence of fire and high temperature refractory lacquer forms a film that forms a heat insulating layer of non-combustible and keramopodobny penokoksa.Also in this process are distinguished incombustible gases that prevent access of oxygen to the timber.

addition to the above, the flame retardant varnish has the following advantages :

• provides a vapor permeable coating;
• texture and color of the surface will remain unchanged;
• explosive and inflammable;
• gives efficiency suppressants first group;
• no odor;
• has no organic solvent;
• not exude substances harmful to humans;
• non-toxic, water based.

What you need to know before varnishing?

Before you start working, heat-resistant varnish is necessary to mix well to form a homogeneous mass.If required, then filtered.If the varnish is very thick, you can dilute it with water, but it should not exceed 3% of the total volume of the material.

surface to be coated with varnish, must be clean and free from dirt and dust.If it has a bituminous or oil stains, they should be removed.In no case can not be mixed with other paint thinners and paint.Also not recommended to apply it on the surface promorozhennaya.

fire-retardant varnish for wood should be applied to those designs that will not come into contact with water and subjected to any machining.This can cause damage and removing lacquer and the loss of appearance.

Apply paint in several ways: by brush, roller or spray.When applied by roller or brush to beware of bubbles, stripes, stains and other defects.If you do it with the help of an air sprayer, nail should create a semblance of fog.

How to paint lacquer work surface?

Apply it should be in two perpendicular directions.Intersecting lanes form a uniform coating over the surface.Also it is necessary to sign up for a jet nebulizer edge to create a uniform layer when painting parallel stripes.

By processing the laminated wood surface should be approached with the utmost responsibility and care.First you need to cover with a thin layer of a low surface area, and if the coating remains intact, and the varnish is uniformly distributed, then you should wait for drying, and then later process the rest of the area.

first layer should be allowed to dry for 8-12 hours, and the subsequent layers must dry for about 4-6 hours at a temperature not lower than 20 ° C.To achieve suppressants first group, you need to cover the surface in 3-4 layers.Thus each layer must be allowed to dry for at least 3 hours.

In the room where will be carried out painting work must be well ventilated.If natural is not enough, then provide compulsory.To work with this varnish, use rubber gloves, goggles and a dust mask to protect the respiratory tract.

surface coated with such a material, long retains its Bioprotective, flame retardants and decorative properties.The term of operation of products for indoor use is at least 10 years.In addition, the treated surface is automatically protected from the appearance of wood coloring and mold fungi.