Modelled plaster - to create a beautiful textural surface of your hands

Preparation of the base under the application of the base layer

When done repair their own hands, embossed plaster is applied to the last stage.Prior to this, the base is prepared, and then covered with a base layer.However, about everything in order.So, first you need to remove from the surface of old wallpaper, paint.If the coating is too tightly held to the wall, it discourage using chisels.First, do a notch depth of about 10 mm, and then all the ground as follows rattles.

If there is any grease stains, they also eliminated.On the cleaned surface put a special primer mixture that increases the adhesive properties (for example, it may be Betokontakt).But the most suitable composition is selected depending on the type of substrate.When the primer coating should ensure that the wall had no stains.After drying of this layer you can start plastering base.But it is also important to choose the appropriate solution for the surface.

Application base plaster layer

When the base is completely ready, you can proceed to the application of the base layer.To do this, it is also important to choose the plaster and cook the mixture (recipe listed on the packaging).In the process of laying will be used trowel and trowel.The thickness of the layer is completely determined in accordance with the unevenness of the walls.The more cavities and cracks, the thicker layer.In order to make the surface perfectly flat, it is possible to mount beacons for

plaster.

are established beacons slats simply.First, one side surface to be treated like composition nashlepyvayut small lumps in the vertical direction.Then they fastened rail.Doing a same and on the other hand.Next stacked trowel plaster solution.Align it with the help of rules applied to the beacons.Racks are removed and the resulting voids in their place also filled mixture.

However, if on the basis of not many irregularities, the beacon may not be used.At the last stage plaster allow time to dry, and only then proceed to further decorating.Used in this case may also completely different decorative plaster relief.It all depends on what effect you want to achieve.

Note! If in the course of these works used lime plaster, the front surface of the coated decorative layer is better to put a pre-acrylic deep penetrating primer.

relief plaster with your hands

relief plaster walls done in the last stage.Apply it could completely different way, depending on what type of surface you want to create.For works acquired special shaped spatulas .With them, you can paint the wall patterns, individual lines, all kinds of shapes.Also, in the process there are different sponge, brush, crumpled wads of paper .In general, anything that will help to create a certain texture.

In that case, when you want to simulate the surface for embossing wallpaper, use rubber stamps (sold in stores).The very best application of the mixture to produce together with a partner.And it does not make the entire wall, and gradually on each treatment site.The first part deals partner thickness equal to the thickness of the grains, and pushed aside.The second begins on the freshly applied layer to create a variety of designs, using the above toolbox.

In the final stage, when the relief plaster, video lessons on drawing which posted on our website, has dried up, possible to start her painting .Thus it is better to lay the composition of strokes on projections or depressions, combining several colors.It is advisable to make smooth transitions and a little shade mixture.The paint is important to use a facade or an interior.After the resulting surface can be covered with any protective topcoat composition.