Setting up the gun - the video and a brief summary of the practice

Setting gun - video material complement portion

theory There are manual and electric sprayers.Classify mechanisms can be provided for a variety of features: pressure sprayer (low and high pressure) to the destination (semi-professional and professional), on the basis of the work (manual and electric).With regard to the principle of ink supply, it can be fed from the top or bottom of a tank by means of forced swap material, or by using an airless spray or combined.

home: better to choose a power tool that can be operated from an ordinary electrical outlet.It is cheap and practical.Typically, users select pneumatic devices.gun device is not difficult.It consists of a base on which the suction and delivery valve, pump, hoses, rods, covers and sleeves with filter for absorption.

Scheme gun too simple to understand, and any examples can be found on the worldwide web.As for consumables, some users can not recommend the use of acrylic and latex paints (for electric models).Although these cases also have their own versions of the devices.

Let us examine the principle of gun

can identify a common principle of the gun: fully applied by the jet passing through the nozzle.This air nail breaks or other consumable material into very small particles, which is formed after the "torch" spray.Naturally, the surface must be carefully cleaned of any dirt, dust and grease.All defects, cracks, scratches and other damage must be ground and the surface itself must be sanded.

Before produce surface finish is required setting gun.Regulated by a few parameters: air pressure, feeding working material and the pattern width.On how correctly divorced finishing liquid depends on the quality of the device, and quality finishes.

First of all, the substance is mixed with the proposed instructions activator.Proportions must be strictly met.However, the paint with an activator is not yet ready for use.Therefore, you need to add in a mixture of the solvent.Then you need to try out how well the device works and how exactly lays down the finishing layer.

Adjustment gun - how to bring the device to perfection?

When ready for use, the device is assembled, the composition is fed to the spray gun, the gun further adjustment is made on the basis of how well the device will work.The substance should not be viscous.It must be sufficiently liquid to not clog the nozzle.The acrylic lacquer is diluted in the same way as the paint.

Now before you set up the spray gun, it is necessary to deal with the width of the plume.In some cases, if the surface is large enough, it is necessary to use the maximum width of the plume, and in other cases, sufficiently small width.When reducing the width of the plume must take into account the air pressure.

next item in "how to set up the spray gun" - control supply paint or other finishing material.To do this, simply open completely or partially close the hole through which the composition is applied.Once you have adjusted the gun under the previous option, you need to take control air supply.

You will need a sheet of paper attached vertically.It is customizable for each type of finishing material in different ways.

So you know how the gun.After some training, you can get the hand to configure the device, and it will happen quickly.If you need to visually see how the gun is adjusted, the video can be found within our articles.