Installation of the shower with their own hands

Shower installed in nearly all new buildings, and in the apartments, operated for many years, often traditional bath changed to a new type of sanitary ware.After all, with the help of this handy item, you can significantly save space, providing comfortable conditions for hygiene.

However, in the history of a shower, there is one annoying moment: quite a difficult installation.Installation of the shower with their own hands, of course, is feasible, but it takes a long time.Therefore, deciding to carry out the work yourself, you should have patience and free time.

procedure for preparatory work

the preparatory phase to study the enclosed cockpit instructions and diagrams.Often trained manufacturer recommendations difficult to make out, but it is necessary to have patience and insight to all.The more detailed you analyze in advance, the fewer questions, how to install the shower with your hands, you will arise, therefore, admit mistakes during assembly less.

then need to take care of the necessary permitting documents.If the car is put in place of the bathroom, you have to not receive anything, and if this device is complemented by existing bathtub, you have to notify the relevant authorities of your village, because more water intake point in the apartment requires registration.

main stages of installation of shower cabin

Whatever kind of this type of plumbing had not been purchased, assembly and installation of the shower enclosure is based on the same stage.Most often, it is angular purchased options.They all include similar elements, among which are:

• rear wall;
• rack;
• side panels;
• roof;
• pallet;
• screen.

To connect these parts, you need sealant, screwdriver, wrench, building a gun, hoses, fum-tape or tow level, screws, washers, nuts, knife.

originally going to shower as a probe in the free space.When it becomes clear that everything works properly collect all the details in place, there is no marriage, you can collect it in the bathroom at a fixed location using the sealant.

When being installed shower, first going to pan.At the same time settling drainage system.The pallet is placed on the support, the level is determined by the direction of the foundation is leveled by tightening the screws.If the model does not provide support, you will need to work with the floor using cement tiles.The acrylic tray do not forget about perekladinkah and fifth pole in the center.

pallet system must be connected tightly with drainer.It is also important to ensure that the slope of the sewer drain hose and drain within 1.5 - 2 cm per meter.

The second step is the assembly of panels and glass façade.The photo and video installation of the shower at this stage is shown in detail.When the panels are inspected, defined upper and lower sides.We must remember that it is on top of the largest number of openings.Slides are distinguished by the width (upper - wider) and the number of cuts (they are at the bottom of the guide).

rails bolted to the rack with screws.The seal is put on the glass.The lower guide is sealed by a sealant.The side panels are fastened to the pallet with screws, sealed with sealant.

glass is affixed only after the complete drying of the sealant.Scheme shower installation implies rollers at the top and bottom of the door.Moreover, if the door is not closed, it is necessary to adjust the top rollers.

Step by Step install a shower enclosure in the final stages recommends to mount the roof.For this we need to put it in line with the holes that are there, and fix them well.

Video installation shower with his hands