Lighting in the bathroom

The bathroom is a room with special effects - splashes of water, hot vapor and other moisture.Also there are sharp changes temperature and condensation occurs.Therefore, the lighting in the bathroom should be performed carefully observing all the electrical safety standards and SNIP (building regulations).According to them, a bathroom should be divided into the following areas:

• area around the perimeter of the bath or shower bowls;
• area with a distance of 60 cm from the perimeter of the bathroom bowl;
• space within 2.4 m from the previous one;
• rest of the space.

For safety, the installation of lighting and other electrical appliances is made at a distance of more than 60 cm away from the perimeter of the sanitary consumer (tubs, sinks, toilets).There is a rule that the wall lights are installed at a minimum height of 2.25 m to protect them from accidental contact with the spray.

for lighting devices in the bathroom and toilet, which are located in the most exposed areas of water, should have a special performance hull integrity.They can distinguish among other labeling: IP 67 and higher numerical value.This also applies to the other elements and electrical consumers.However, common today, was built in showers lighting that eliminates the installation of devices in the hazardous area.

wiring insulation must be carried out not only the electrical insulating tape, but shrinking - a material which when heated or gas burner lighter, shrinks and creates a waterproof coating.

Whether it's the lighting in the bathroom Khrushchev or modern buildings - without a difference, it must be strong, because the room is dark and has no sources at all day and evening light.In this room it is more expedient to use halogen or LED lamps with high lighting power.

Instruments best to choose a course of action, the reflector and the ceiling installation method to use with vertical lighting down.This is due to finish the walls of bathrooms - most with lining, which has the ability to produce a lot of glare, unfavorable view.Areas with the highest concentration must be light - area with a mirror and a door, there is positioned most devices.

Photo

separate specific reception is perimeter lighting or illuminated glass floor, ie the floor of reinforced thick glass under which there is a layer of water and sealed lighting, LED strip.It requires special skills masters of performing these types of operations.You can read these design ideas by viewing the photo lighting in bathrooms and their embodiments in reality.

There are special programs for modeling bathrooms in 3D, through which you can create your own design project finishes and lighting, but it is only by professional designers, to the need to understand a very long time.