Abyssinian well with their hands

not always possible to ensure a country house with central water supply.There are several other possibilities to adjust the flow of water suitable for drinking and household needs.One of them - Abyssinian is drilling the well, and how to build, can be found in this article.

What is it?

What Abyssinian well?So called shallow wells (less than 9 meters), the water from which it is possible to lift the pump.For the first time since the British began to receive water when committed campaign in Abyssinia.In another such method may be called a tubular, as the basis of - iron pipe.And also - Norton - at creator names.

This method of water extraction are not always acceptable.To do this, aquifers should take place in the upper part of the sand.Therefore, before the excavation is best to consult with specialists or ask the neighbors.Well this type of easily dug only in sandy soil, if the soil is rocky, it is necessary to do the usual well.

Design features Abyssinian well

1. pipe for water supply (it is the national team, so the need for coupling and sealing of joints).
2. Hardened steel tip (needle).
3. filter.
4. valve inlet.
5. pump.

design nuances are reflected in the drawing.

features facilities such well

It is necessary to break the ground for this, take the pipe diameter from 25 to 75mm and hammered it into the ground.Before her to drive into the ground, it is necessary to drill holes in it.They are made of 10 mm diameter, 50 mm recede from each other to meet staggered.In another way it is impossible, or stiffness gets worse.Between the rows of holes left to a distance of 50 cm.

tube is provided with a mesh of stainless steel or plastic.Its purpose - to hold up sand particles, to avoid silting.Grid better solder flux or special tin solder.This will prevent water intoxication.It turns out a kind of filter for Abyssinian well.

tube equipped with a pointed end of a part - needle.Its length is 20 to 30 cm. The scheme illustrates the characteristics of the element.Such a construction is necessary to facilitate the progress of the pipe in the ground.

Abyssinian well hammered just after passing the upper layer of dry soil.This process is a garden drill.The pipes will be driven into the ground at a time, the components are connected in the process.The video shows highlights to create a hole.

first pipe drives using the iron women, further work is carried out by means of the framework of the drill.When the first tube is fully seated in the ground screw on the pipe should be new.If Abyssinian wells of plastic pipes, use a different connection method - vplavlivanie.The joints are closed tight seals to prevent water leak.

When the aquifer is reached, the work is completed and a strong jet of water cleans the filter element.Then the pump is mounted and begin to pump water out until the water is clear.

How to choose the right place?

This type of well is dangerous because the water may be contaminated by sewage revenues.Therefore, choosing a well site should be as far away from any areas where there are waste water in abundance.From the septic tank distance should be at least 20 meters.This is despite the fine soil, which perfectly cleans the water.If the soil is coarse, the distance increases in 2 more times.

If there was a question how to make the Abyssinian well with their hands, so that the water in it was clean and safe, it is necessary to know that the depth of the well should be at least 4 meters.If the water has gone before, which means that it is ground water, which contains many dangerous impurities.

Benefits Abyssinian wells

This type of well has a number of advantages:

• the photo shows that the work is carried out without special equipment, many assistants also not necessary;
• design takes up little space;
• pump can be installed in the back room;
• tube eliminates the ingress of soil polluted waters;
• work is carried out quickly;
• costs are minimal.

Video drilling Abyssinian well with their hands