Steam from SIP panels

Independently construct a bath of SIP (SIP) -panels not difficult if you follow the steps below.

Using SIP panels for the construction of a bath with his hands is absolutely good decision, because will significantly save finances and construction time.This building material has several advantages, which is what sets it among peers.The main ones include:

• high rates of heat and sound insulation;
• weight of the material;
• quick installation.

Foundation

That light weight allows buildings to equip them for the foundation of facilitated type, for example such as in the photo - a screw-pile foundation.

Using this kind of base will significantly reduce the total construction budget.Also from Bath of SIP-panels erected very quickly and has a high level of seismic resistance.

Installation floor in the bath

Before proceeding to the arrangement of the floor in the bath of SIP panels, should be treated with antiseptics and special fire-fighting compositions in layer 2 all wood-frame elements.Each layer should be allowed to dry completely.

Then proceed to the installation of the floor, complete the following steps:

1. Fasten the board (thickness 50 mm, width 250 mm) to the posts of the foundation.Fixing is by means of galvanized fasteners to the foundation piles.

2. Make the sill (full).On its inner perimeter nails fasten the board (thickness 50 mm, width 250 mm).Tying is repeated three times, and becomes a solid foundation of the future building.

3. On the resulting base layer is laid ready SIP panels, pre-treating them with asphalt primer on both sides and further fixing the place of individual sheets of joints.

Assembling wall frame

Step counters depends on the width of SIP panels.

carcass building walls in the following order:

1. Around the perimeter of the future baths fasten flat board, the width of which corresponds to the internal size of the CIP panel width, which makes it comfortable to install them vertically.

2. According to this principle set all the details around the perimeter, clearly adjusting the size of the size and form the inner walls of the room.To this end, the side walls corresponding to the width fasten wooden rails (required squareness control level) and have them install partitions.It is not necessary at this forget about the door and window openings, laid down in the draft.

3. Next, perform the upper harness, check the accuracy of the installation of all components and reliably fix.

4. Top ceiling laid a layer of panels.

5. done plums.Sewer pipe is displayed in the septic tank.

It should be noted that all the plates are mounted on the tongue and groove system.And everything, even the small gap for high quality sealing, blow out with foam.

Mounting roof

Before installation hipped roof bath of SIP panels, all the elements of wood treated with fire retardant and antiseptic.Allow the wood to dry out.

Then we must act as follows:

1. Along the perimeter of the future top baths fix mauerlat.

2. In the center of the ridge board fastened.

3. First Equips extreme rafters, and then internal, 0.5 m increments.They Scrollsaw corners to provide better stop.

4. Now carry out installation mezhdustropilnyh jumpers, as well as an end piece and do overhangs.

5. Cover the surface of the waterproofing material.Overlap needs at least 15-20cm.

6. Top stuffed kontrobreshetka.Then the crate.

7. The final step - fixing the roofing material (requires an air gap of 20-30 mm waterproofing).More details about the installation of metal.

Completion

then sheathed base.

are installed doors and windows.Done porch.

Inside the room is sheathed clapboard.

In conclusion I would like to note that the built in compliance with all technological nuances of Bath SIP panels with their own hands, will be able to serve the owners for many years.

Options exterior and interior finishes its great variety.It all depends on taste preferences and financial capacity owners.

Video building baths of SIP panels with their hands