How to round off the corners of the walls in the apartment

Materials and tools for rounding

• Roulette
• Pencil and ruler (profile bar, all of which can help in smooth drafting)
• Bulgarka
• Drill with screwdriver
• Jigsaw
• Punch
• Screwdriver
• nazhdachkoy
• Spatula
• Taz (for coats and plaster)
• primer and plaster
• wooden plank
• Plywood
• Corners
• Painting

How to round a corner: step by step instructions.Step 1: measured the radius of the future of a smooth angle

Started marked measurements of the radius of curvature of the future.It is necessary to measure out a certain amount of centimeters on both sides over the entire height of the angle.Also be sure to note the radius of the ceiling and the floor.

Step 2: Making a mark roundings

places the mark in the floor and ceiling attach otbivochnogo thread (the one that leaves an imprint on the surface of the touch) and will get a straight line boundaries for crushing angle.In the absence of thread, use a metal profile and draw a pencil line.

Step 3: cut plaster

In order to cut the corner, you'll need a Bulgarian.It is necessary to cut off the part of the plaster that covers the angle of the wall before the split.To make incisions on the mark to the brickwork.

Step 4: mark up the template for rounding

template required to create a smooth shape angle.To produce required wooden board on which the compass Draw a circle.

Next draw a tangent line at a distance of 5-7 cm from the circumference, which differ by 90 °.As a result, should get a trapezoid.

Step 5: Scrollsaw

template Take the jigsaw and carefully proceed to saw cut the board to the designated lines.

At completion, you need to get the arch, the edge of which should be roughened by sandpaper.Above pattern screw smooth bar that will fix it and do not allow to bend.There is also a need to attach the ends of the bar to ensure squareness.

Step 6: paint rule (pattern)

to pattern is not subjected to distortion due to ingress of water, is to paint it.Edges are most vulnerable to moisture, therefore they need to paint the most intense, even in several layers.

Step 7: break through the corner

make round corner should be within the template that you noted earlier.Take a hammer and repel the plaster to a brick.Then proceed to giving a rounded shape brick.Adjudged metal rods are cut off grinder.

Due pattern can constantly check the desired result.

Step 8: gruntuem angle

Before the plaster, you need to be primed surface.This will improve its adhesiveness and do all masonry is significantly stronger.Take a large brush and sweeping motions with a lot of makeup, apply a primer to the surface.

simple way to allow ordinary watering wall primer straight from the bottle.

Step 9: Prepare a corner to finish

If the template for the log cabins of the angle passes exactly, can be applied plaster.However, if the deviation is still present, attach to the wall profile to one of the edges of the pattern came up against him, and he could move the pattern on the surface.

Step 10: Plasterer rounding

advance angle Take kneaded plaster and sprinkles it with a spatula at an angle so that it appeared considerably beyond the borders.Then draw the pattern (rule) up and down, spreading and smoothing the plaster surface.

As a result, you get organic corners rather than concrete structures, as is usually done in other ways.And the angle will be one of the central elements of the decor in the room, as it can be arranged with paint, stone, decorative plaster, etc.

Good luck to you repair!