How to lay tiles on the oven to keep it collapsed in the first protopku ?

tiles especially for lining furnaces

Choosing material for lining furnaces, keep in mind that not every option is suitable for finishing.Tile furnace must necessarily have a high heat resistance and durability, the thickness be at least 6.10 mm and to have low porosity structure.

these properties fully meet only a few kinds of veneering ceramic tiles - tiles, terracotta, porcelain, majolica and clinker.It should be chosen not only on appearance but also on the purpose of the room.For example, for decoration of bath furnace is necessary to take into account the technical characteristics of the heat-premises and for home - and even match the interior of the house.

Surface preparation furnace and tools for work

Before you lay the tiles on the stove, you need to check how well prepared surface, after which the material should be sorted by color and size.The tile must be expanded in individual color pile face up, then use the template - by size (as trim elements may be small deviations).

The following is the preparation of the oven do: it must be well cleaned of old paint, clay, and in general from all that hinders smooth tiled.steel brush will work well for cleaning.It is also necessary to pay attention to the seams: they have to be cleaned to a depth of about 1 cm in order to ensure the strength of the masonry, the furnace can obtyanut metal mesh that must be applied to the solution layer in the ratio:. Cement - 1 part sand - clay and 1.2- 1.3.

for stacking can use special ready or dry mixes that are sold in DIY stores, or you can make a mixture by: mix 2 parts of mining sand and 1 part river sand and cement, add 200 grams of salt to keep the water in the solution (in terms ofa bucket of solution).

To execute facing need the following tools:

• steel hammer weighing 60-80 g, has a sharp tip for razrubaniya;
• suture pads;
• spatula;
• steel cutter, roller glass cutter for cutting tiles or machine for cutting tiles;
• template;
• emery bar for pritochki tiles;
• wooden support for pressing the material to the surface;
• square, rule or level.

How to lay tiles on the oven?

Laying tiles on the oven must start from the bottom, first fit the whole tile, and in the end - cut.Ready solution applied to the tiles on the reverse side, it is necessary to distribute evenly over the entire surface with a spatula.Then the tiles tightly to the surface of the oven and lightly rap the gavel.

To ensure the same distance between them tiled align the seam seals, then straighten each row level.To paved surface was perfect, each row must be supported with a block of wood supports, rests on the floor.

After laying tiles to complete the oven and the solution was solidified almost need to wash it with soapy water using a sponge.Then give a solution to cure at least 24 hours.Then you need to embroider seams viscous flame retardant solution and perform grout, and after 10 minutes, wipe the surface with a damp sponge and remove any excess solution.

When suture solution dries, the lining material should be polished with a soft cloth.The oven can be used on the next day after the grouting.Laying tiles - it's pretty hard work, but knowing how to put the tiles on the stove and what tools you need to prepare, you can greatly facilitate their work.