Deck board - Larch for decoration of terraces and paths with their own hands

What are the advantages of larch?

If we consider the Siberian larch, which is often used for walls and floors, it is possible to identify a number of advantages.Firstly, it is extremely hard and durable material .According to the mechanical characteristics can be compared with the oak.Second, thanks to the special composition of the resin, the tree has excellent resistance to fungi .Third, the wood has a good color and a pronounced texture.Because the coating obtained aesthetically appealing.

Fourth, this tree moisture resistance , it can be used both indoors and outdoors.That is why the lumber from larch so often used for decoration of porches, patios and other areas.Fifth, it is an environmentally friendly material , which, moreover, contains antioxidants.Recall that they neutralize the effects on the body from all sorts of environmental contamination.Plus, it has medicinal properties .And, sixth, this wood has low thermal conductivity .

deck board - Larch: scope

Deck plank (or even call it decking) is used to trim the seats, where you can often slip, namely, on the street.Because it is used for lining the floor on the veranda, terrace, in the gazebo and other places.Decking is very strong and durable.it becomes a better Every year since released polymerizes the resin coating.

In addition, there is a kind of material, which is called the decking.In fact, it's the same board used for outdoor flooring at street markets.That is, you can create and garden paths.Special relief profile, available on the front side, does not allow to slip at any time of the year.

Use the deck board in the sauna and bath.This is due to the fact that the tree is not afraid of water and do not rot.In addition to lining out of it, you can do all sorts of things (pails, cans, benches, etc.).All interior elements are very attractive, thanks to the special texture of the wood.However, it is worth remembering that any coating somehow need additional protection by using a paste wax or lacquer (sometimes fit parquet).

few tips on laying

Laying decking made mostly perpendicular to the (so-called deck method).It can lay on the concrete surface or wooden joists.In a first embodiment, the alignment is done using a special tie.Once the base is ready, larch plank - Edged board at a slight incline, sufficient to 1 degree.It is necessary to ensure that the water flowed freely to the surface.

If as a base for tiling will apply lag, it is necessary to make the distance between them in direct proportion of the estimated load.For example, if it is done for the car parking, the distance should be about 20 cm. When creating paths and other surfaces with lower expected load, the interval can be 40 cm. Spread the deck board is strictly perpendicular to the joists, though they are attached terminal.

Note! important point when installing expansion joints are at a rate of 5-7 mm (per meter).They are needed to avoid deformation of the boards in the case of sudden changes in temperature.If they are not made, the coating can deteriorate as soon as possible.