Fences

August 12, 2017 18:05

Eurofences own hands

Fences

click fraud protection

Eurofences attract practicality, durability and beautiful appearance.They are easily and quickly installed on any ground without a foundation.But the most important advantage is that the Euro fences can be made with your own hands.On sale are many different forms for concrete DIN rail enclosures.You can make a panel that will fit well in the plot the composition.Perhaps the process of manufacturing the plates does not seem too complicated and time consuming and would be a home business, bringing a good income.

Content

Equipment for the production of decorative concrete fences
fabrication eurofences instructions with their hands
Installation eurofences own hands
Photo eurofences own hands
Video installation eurofences own hands

cheapness and variety of panels attract buyers, so the demand for concrete fence falls.

Equipment for the production of decorative concrete fences

To cast eurofences his hands need:

Moulds, panels and pillars.

Matrix of ABS plastic does not adhere to the concrete, so they do not need to process the lubricant demoulding.They withstand heavy loads easily restored if necessary.PVC plastic forms are slightly cheaper reliably transmit relief quickly pay for themselves.

Mixer.

Depending on the goals selected drum volume.

vibrating table.

Allows you to obtain a homogeneous concrete mix and perform reinforcement.

Wooden pallets.

are intended for drying panels.

welding machine.

is needed for the production of a reinforcing frame.

metal wire or rebar with diameter of 4-6 mm.
grained gravel, sand, cement, plasticizers.
primer and exterior paint.

fabrication eurofences instructions with their hands

on a vibration table set form.

panels for low-carbon steel wire frame is made in a grid with a mesh of about 10 to 10 cm. The fittings used for the production of poles.

backfilled into the mixer: one part cement, two parts sand and three parts gravel and water.The plasticizer facilitates rapid curing, is added about 0.5% by weight of the total ingredients.To increase the water resistance and frost resistance of concrete sections can be added water-repellent agent.

As eurofences gradually make their own hands, you can see in the photo.

In post production of two fragments prepared valves are installed in front of each other and filled with concrete.After ten seconds the form is removed from the vibrating table, overturned on a pallet and removed.

To produce sections eurofences when the vibrator is loaded mixture to half the volume form.Then it laid prepared wire frame, and container is filled to the brim.Surplus mix removed spatula.The form is turned on and remove the shield.

products are wetted with water and kept at ambient temperature for two days.When steaming seven hours eurofences fragments can be sent to the warehouse.

Razopalubka slabs and pillars must be carried out immediately after filling and sealing.In this case, with one form of the day can make several panels.

Installation eurofences own hands

Installation eurofences with his hands held in several stages:

After marking the site dug recesses for pillars.
finished concrete solution.
Bollards installed, filled with concrete and fixed.
After solidification of the solution panel attached to the guide grooves pillars.