Install the towel warmer in the bathroom

Today it is impossible to imagine in the bathroom did not have a special device for drying towels and fine linen.The installation towel warmer in the room is the same necessity, as well as all the other plumbing fixtures.And it is not only important in the sense that such a device will need to dry towels.Of great importance is the fact that the bathroom there is a constantly moist air, so using a towel warmer can be controlled with an excess of moisture.

Choice towel warmer

The installation towel warmer in the bathroomnot much of a challenge.Much harder to choose the right device.And although there are only two basic types, but it is very difficult to a single preferred.

1. first type - is electric towel warmers.They are very convenient, but the problem lies in the fact that they draw too much power.
2. second type - the water, which are connected to the main home heating system.In such devices, there is a second problem - they can carry out their direct functions only in winter, when heating is included.

Preparation for mounting the towel warmer in the bathroom

most favorable installation towel warmer with their hands on the riser with the hot water.For this it is necessary to lengthen the pipe with hot water to the sink or in the shower.In this case, even in the summer it will be convenient to dry towels or fine linen.If you see a video installation polotentsesushitlya, it will become much clearer, as it is more correctly to do and where the bathroom is more convenient to arrange such a device.

This setup will allow to have a towel warmer water in the wet room with an extra loop of hot water that will both warm up the room, so wet and dry air.It is necessary to install the towel warmer was a scheme, because even a small error during assembly can affect the entire plumbing.

Before placing the towel dryer installation, you must create a step by step instructions.This step by step guide installing towel warmer will determine not just what will be needed parts, but also how to connect the device.If you look at a photo installation towel warmer, you can determine what additional parts required for such work.

It is important not to forget on both sides of the device on the riser to install two ball valves.This will allow in the future to change or repair the heated towel rail, keeping all the water from the system or closing the valve common supply of hot water in the entrance.Step by step instructions

If you become familiar with the instructions step by step, it will be possible to understand how to install the towel rail with his hands.

1. The apartment building must first report to the housing office that was closed to the hot water at the entrance.

2. On the riser installed bypass valve having a 3 - it will change or repair the towel rail off without filing a common hot water.

3. To fasten the wall bracket, which is fixed towel rail.

4. This device is connected to the bypass valve;connection occurs either by bushings or through special fittings.When connecting you must not forget the gaskets.

5. To avoid water hammer appeared in the water, taps should be opened slowly to a heated towel rail gradually filled with hot water.

Video installation towel warmer with their hands