Sliding doors with their hands

quality gate rolls back toward the opening and closing, can save space on the site.They are simple and easy to install, durable and attractive appearance.Profiled fixed to the frame, protect the area from wind gusts and considerably reduce the noise in the area.Install sliding doors with their hands is not difficult, just need to properly carry out training and to take into account the basic requirements of the manufacturer.

Drawings

Simplesliding gate design assumes the support elements supporting the supporting frame and feigned.The depth of the foundation for the goal with a cloth to 3.5 m (distance between the foundations of 3.175 m) shall not be less than 1.5 m below ground and 2.5 cm above the ground.Under the base frame must be filled with a larger foundation: that it will go to maximum load.Its length is 2.4 meters and width of 50 cm. Under the feigned frame must be filled with a small base, 50 cm long and 30 cm wide. More support portions layout allows accurate and error-free and lead casting, and mounting frames.

Pouring the foundation

So, how to make their own sliding doors and what materials are needed for proper installation of supports?For pouring the foundation used concrete grade M200 or higher.Before pouring the trenches necessary to carry out reinforcement bars 12 mm in diameter.The resulting base was allowed to stand for a week.

Assembly instructions sliding gates

Work in accordance with the instructions included with the kit components.It will also be useful for the Executive and the following description.The algorithm allows faster and more accurate to carry out the work and to prepare a robust design:

M8 bolts connects the angular frame and sliding canvas.

holes on the frame and the gate are covered by plastic plugs.

guide bar is attached to the bottom of the recoil of the web.

along the interface bus and the web, the inside of the gate C-profile is fastened using roofing screws.

The C-shaped profile set sets consisting of embedded plates, screws, nuts bilateral (detailed assembly kit available in the video).

Bilateral nuts attached rack (according to the factory holes).

is important to consider the distance between adjacent slats: it should be no more than 1-2 mm.After correct positioning of the elements can be done bilaterally tight clamp nut that will reliably fix components.

Proper installation of sliding doors on the rollers and also involves tightening the bolts to fasten the rack to the fasteners on the profile.Detailed drawings and photos, these instructions will help ensure the accuracy of execution.

on prepared foundations necessary to establish a reference frame and feigned by level.To do this, hold the markup and then prepare the hole.

differential between the bases should not be.Fixing is done using M12 wedge anchors.Adjust the columns strictly vertical.

Next collected and fixed all the other accessories for sliding doors: fasteners for clips, commercials.Before installing them require accurate counting of free area and the elimination of differences in the plane or slight slopes frames.The distance from the base frame to the first fixer is 10 cm and the distance between adjacent fasteners -.. 1,335 m

After preparation of fasteners is performedinstallation of roller bearings.

The support frame assembly of rollers carried by a small bus.

Next installs collected at the gate roller bearings (work should be done 3-4 people).

Along the edges of the corner frame fixed rubber rollers that provide softness and orderly progress Gate.

From the corner it is necessary to install the plug.

On the opposite side, set the support roller.

finalized installation of sliding gates of corrugated board after mounting the collectors on the mock frame.

After the trial opening / closing when necessary is done tightening and adjustment of the structure.

actuator is mounted to the inner side of the gate, next to the support frame.Wiring the drive, automation and customization features of its operation are specified in the instructions supplied with the kit.

Video installation sliding gates with their hands