How to remove the chandelier from the ceiling - a step by step guide

Options dismantling

to wash the dust from the lamp is not necessary to completely disassemble the structure and disconnect the wires.In this case, quite gently remove the ceiling on the chandelier, which is attached to the clamps or screws.Nothing complicated there - look for fasteners, and dismantle their own hands.Sometimes the cover is removed even easier - unscrewed counterclockwise, and still there are structures in which the cover is kept as spot lamp - on spacers.In this case, we must act in the same way as when removing the spotlights - gently pull the cover on until it is completely out of arching legs.

Another case when you need to remove the chandelier to repair and for some time to hang a regular patron.In this case it is necessary to disconnect the lamp to have access to the wires from the ceiling.The new cartridge is connected is quite simple - conductors must be got into the corresponding terminals on the cartridge.The main thing is to fail the plinth neutral rather than phase.

If you decide to hang a new ceiling light, you must first remove the old chandelier, completely dismantled structures and leaving only the input wires on the ceiling.We must act by analogy with the previous version and now we look at step by step instructions to dismantle their own hands.

Step by Step

So, to remove himself from the ceiling chandelier, you should do the following:

1. Turn off electricity at the introductory panel.If you just turn off the light in the room, still there is a possibility of electric shock, so it's best to protect yourself and completely disconnect the network in the apartment.
2. Prepare indicator screwdriver terminal blocks (better WAGO), duct tape and a stepladder.This is all that is needed to remove the lamp from the ceiling.
3. Check the light in the room, utilizing the switch.If the lamp is not lit - you can begin to dismantle.
4. First try to remove the lamp with all the fragile items - glass tassels, lamps, ceiling, etc.
5. Then remove the decorative cap that hides the connection wires from the ceiling.Usually the protection secured central locking screw or nut, which is not so difficult to detect.
6. Once the cap down the bar will move down, you will see on what mounted lamp - hook or bracket.In the first case, the wire can be immediately disconnected and dissolve away, then dismount the hook device.Remove the chandelier on the bar a little harder, becausefirst have a little weaker than the bolts, which holds bladed mount.
7. When wires are disconnected, carefully insulate all 3 bare wires on the ceiling, so that they are not shorted, and not to cause electric shock.

That's all you need to do in order to independently remove the chandelier from the ceiling of the house and apartment.As you can see, nothing complicated, important not to hurry and to be careful.In addition to this, we recommend you to read the tips provided below, which can be necessary in unusual situations.

What else you need to know?

Sometimes the design of the lamp or ceiling material can be driven into a dead end when you decide to remove the chandelier, which weighs in the room.To ensure that you do not have difficulty with the dismantling works, consider the following nuances:

• To remove the chandelier plate (shown in the photo below), you must first find the screws that secure it to the ceiling.As a rule, a little bolts recessed into the ceiling, reminiscent of the plate.Remove them with a Phillips screwdriver, you can, just make sure your other hand, hold the product.
• to install chandeliers in tension or ceiling mount can be used one-time, which is better not to remove (for example, butterflies).Otherwise, for subsequent installation will have to buy new fixtures, although you could just do not touch the old.
• Before disconnects twist wires (or terminal block), once again display a screwdriver, check the voltage.It takes less than a minute, but you sure will be assured of the absence of electricity on the line.
• In no case do not get to work with the power turned on.Although, in fact, the light switch must remove the voltage from the light bulb, some would-be electricians sum tear to the switch does not phase and zero.As a result, even when the circuit breaker will be electricity to the light bulb, and you may get an electric shock.

And finally recommend that you review the video, which shows several ways to wash chandelier, without removing it from the ceiling:

That's all that I wanted to tell youhow to remove the chandelier from the ceiling with his hands.We hope that the material was useful and interesting for you!

Also read:

• At what height to hang sconces
• How to find a wire in the wall live
• Proper placement of light fixtures on the ceiling