How to drill tile on the wall - tips and rules

Repair accompanies any person throughout his life.Many have a certain experience of repair work - or do something to do, or watched as others do.But sometimes there are questions, understand that can only be a specialist in conducting these most repairs.One such issue is the common problem - how to drill the tile before applying it.And we have to do quite often.

we decided to hang in the bathroom cabinet, the supply outlet.Many have tried to do that, especially not "bothered" about it.As a result - and the tile splinters or cracking that no better.And, as a supplement - an expressive, colorful and unique monologue wife about her husband's hands.The period of reflection: what and how to close up the resulting hole.Therefore, you should know the basic rules of ceramic drill - this knowledge does not harm anyone, and do not interfere.

drilling rules tile

Before you begin, you should check what is behind this tile - solid or hollow wall.For this rattle tile.If the ringing hollow, the voids there, if the calls are - there.Therefore, you need to drill with extreme caution, and it is best to drill elsewhere.Not recommended drilling and in the corners of the room.

must know that for drilling large holes (underneath the pipe, for example) is used milling of carbide material or a circular drill, called "Ballerina".You can also use small-diameter drills with pobeditovym tip for drilling small holes.It can be a small-diameter drill hole and drill for metal, but it quickly wears out and no longer subject to exploitation.You can try to beat the frosting in place of drilling by means of the sharp end of the tap, for example.If the glaze is removed, the drill bit "crawl" will not.

used for drilling electric drill, but it's better to use a hammer.After tiles are usually drilled for a reason, and in order to hammer a nail into the hole and tighten the screw.

When drilling tiles there is a big challenge - how to fix the drill bit to keep it from sliding on the glaze.Therefore, it is required to make the hole was not slippery surface for the drill.It is possible to place drilling stick adhesive tape, scotch tape, masking tape - it will help keep the drill in one place.There is another way: in the intended location for drilling a thin drill designed for drilling glass, drilled a small bevel.That it will then hold a working drill in one place.

Note that the drill should be kept strictly perpendicular to the drilling surface.To prevent overheating of the tip of the drill should be periodically cooled in cold water.For more convenient drilling walls and tiles in order to avoid a split with the diameter of the hole in the tile itself to do a little larger than the diameter of required holes in the wall to drill the tile is not concerned.