Hvordan å henge en lysekrone rett

strokes finishing repairs in the apartment, is a suspension ceiling chandeliers.Hanging lamp fits well in the majority of residential interiors.The operation of its installation requires a minimum knowledge of the basics of electrical engineering and self-confidence.Prepare the necessary tools, buy the lamp, reset the memory handling rules with electricity and - for the cause.

What would install a chandelier on the ceiling with his hands need:

- ladder;
- electric with the function of the gun;
- Screwdriver indicator;
- pliers with insulated handles;
- wire cutters;
- Screwdriver;
- adhesive tape;
- unit wire clamp.

Prepare a hook, to which will be attached chandelier.If the ceiling light in the room previously was not provided, proceed in the center of the ceiling hole puncher.It must be in close proximity to the exit point of electrical wires.Hook Attach to the ceiling anchor method, and then wrap it with two layers of adhesive tape.

Read the installation instructions if it is attached to a chandelier.Typically, in the description of the lamp makes recommendations for its installation.If the instructions indicate that the design involves grounding, be sure to keep this in mind when installing.If this seems difficult, call the electrician business professional and it will install.

Disconnect the power supply from the premises using the circuit breakers on the distribution switch box.When the switch carefully check the screwdriver-indicator mounted in the absence of voltage network.After checking the slide switch to the off position.

Widget from SocialMart

Proceed with the installation.Locate the three wires on the ceiling: the "zero" and the two-phase.The neutral wire goes into the mounting box and the phase output to the switch.On each wire, remove the insulation part and spread the ends peeled apart to prevent accidental closure.bare tip length should be 3-5 mm.

Determine which wire is the "zero", and what - phase.Turn on electricity again in the room.In turn indicator to touch the tips of the wires.A lit LED will indicate the "phase", the absence of light bulb glow indicates that you have found the neutral wire.Mark the "neutral" with a piece of adhesive tape.

Install Phase lamp wires.Typically, electric chandeliers are marked accordingly.Usually three working wires laid in the tube and displayed on the mounting block to the terminals.The block then removed under a decorative lamp cartridge.

In the absence of markings on the line turn into a power outlet of any two wires extending from the lamp, without touching at the same time to the third output.When light up half the bulbs, mark included tape wires.One of them leave in the outlet and in the second place, set the third wire.If lit up the other half of tubes, it indicates that you have found a second phase output.The wire which during the operation remained in the outlet will be "zero".

Carefully hang a chandelier on the hook.Connect "zero" chandeliers wire end with the same electric network on the ceiling.Connect with each other and also the phase conductors.Do not use solder for joining copper and aluminum wires.Use for mounting special clamping unit.

After the installation of wires set into place a decorative holder, achieving to the wire and the clamping unit are hidden.Apply power to the chandelier and make sure the connection is made correctly.

Useful advice on repair of apartments.