How to cut the corner on the ceiling moldings

decorative moldings - a decorative element that gives the completeness of the walls and ceiling.His stick at the junction between the walls and the ceiling on special glue, with the greatest difficulty usually cause the corners, both internal and external.How to cut the corner on the ceiling moldings, not to leave gaps and dents?This question is probably asked everyone who has ever tried to glue the ceiling moldings with their own hands.

Species ceiling moldings

decorative moldings - otherwise it is called fillet - can be made of different materials: wood, plastic, polyurethane, polystyrene or polyvinyl chloride.They also vary in width and form of relief - it can be simple or curly.Fillet simple form easily join in the corners without special fittings for a wide plinth with moldings better not regret the money and buy a special corner elements - the inner and outer corners of the same materiala.Plintus of wood and polyurethane cut sawing metal or solid with a sharp knife.Polystyrene and PVC skirting boards are easy to cut the usual stationery knife, thanks to the fine edge he did not gloss over this fragile material.

How to cut the plinth to the right angle

most convenient way, virtually eliminates inconsistencies - is to use a miter box.This device is a template U-shaped with slits in the side walls, made from different angles.Skirting mark out the place, noting its maximum length of the ceiling for external corners and along the walls for interior.Plinth placed in a miter box, align and cut at an angle of 45 degrees.

In the absence of a template can be done miter box made of cardboard or heavy paper, drawing a line on it at an angle of 45 degrees with a protractor.The fillet is applied parallel to the edge of the sheet to the marking lines, and cut with a sharp knife along the ruler.

If one segment of the plinth must be cut right angle on both sides, it is recommended to start with a more complex - external or uneven angle.

What if the internal angle is not straight

walls in our homes is not always perfect, and the angle may be more or less than 90 degrees.In this case, a standard template will not work, and it is better to use markup in place.To do this, you need a solid stick - it leaves less residue on the ceiling.

plinth is applied alternately to each of the walls forming the corner, and he traced by the edge of the ceiling line.The intersection on the baseboards annotation lines.Connect it to the lower edge of the skirting is cut at an angle and the angle of the knife with a ruler.Cropped this way skirting exactly fall into any corner.

fillet with stucco difficult to dock in the corners without the use of special parts, but if you are unable to pick up accessories to the embossed plinth, do not despair - with the help of the following methods can be correctly cut the corner on the ceilingbaseboard any form.Dock skirting better in a place with the most prominent elements of the stucco so that the overall picture is not disturbed, and the joint carefully prokleivat.In this case, the fillet will look neat and perfectly fit into the design.