Build Daily

Rooms

August 12, 2017 18:07

Molded bathroom - sort out the building stereotypes

click fraud protection

Molded bathroom - overview of the characteristics

When we hear the term "batten", it is natural to present the wooden finish of the edging boards.This decoration recently very widely used for creating interesting solutions in the interior design of premises.What to do if you want to use this material for finishing baths, sauna or bathroom?

And limited to whether the term is a concept of a wooden component?Far from it, the same name used for PVC panels.And it plastic linings for bathroom is a great alternative to ceramic tiles and other materials used for decoration of the premises.

plastic lining in the bathroom is quite right to exist, because it has a number of advantages:

  • comparative cheapness of the material, various colors;
  • easy to install, requiring no special skills;
  • PVC panels are not afraid of moisture;
  • the installation of the ceiling is possible to use built-in lighting fixtures;
  • easy maintenance.

In addition, PVC panels warmer to the touch than ceramic tiles, consequently, condensation is formed on them much less.In a plastic lining, as well, and wood, there is one, but significant drawback.When installing the lining "eat" are necessary centimeters of useful area.

Can the wood paneling in the bathroom?

As mentioned above, sometimes really want to decorate a bathroom namely wooden clapboard .Though long known that moisture is the eternal enemy of wood, but the use of modern special means can significantly reduce exposure to wood material his old enemy.

preparation for the implementation of such finishes in the bathroom, you need to understand that an absolute guarantee of the existence of this durable liner nobody will.But in order to maximize the useful life of the material, you must adhere to certain rules of the installation of wooden bunks.

wood paneling in wet areas should be mounted so that its reverse side is constantly purged with air.Simply put, this cladding must be constantly "ventilated".To solve the problem of access of air to the back of the lining can be made technological holes in the floor and ceiling of the room.

Do not set the horizontal battens, asThis provision will promote the rails stagnation of water in the grooves facing.It is desirable in such rooms battens mounted with vertical slats, becausethis will contribute to run-off water and condensate without delay.

In addition, to improve the run-off water such good trim varnish and wax.Another important factor, which will serve as a wooden bunk longer is originally quality lumber that was used for its production.

When buying lining should go through each board by hand, paying attention to the slightest defects in timber and select only high-quality material.Otherwise, your facing any pleasure does not deliver, and you will lose money and gain a lot of problems.

Mount battens correctly

Before implement trim clapboard , bathroom must be properly prepared.It is necessary to mount a skeleton under facing.To create a frame with screws needed to fix horizontal wooden slats on the walls of the same thickness.The distance between the rails should not exceed 0.5 m.

Fixing plastic lining is carried out by special screws or staples.After that, you need to measure and cut the desired height of the panel, cut PVC panel saw or a hacksaw.

Any violation of the material integrity of the sharp edges are formed.To protect themselves at work and do not cut yourself on sharp cut edge of the panel, it can be a fine sandpaper to clean.The procedure works like this: the first panel is inserted into the starter strip and fastened along the edge on the frame rail.Already from it will build all the work.So in the same way the rest of the panel are mounted.

instagram viewer