As wallpaper glue on MDF high quality and reliable?

what and what should be done?

The entire process consists of the following items:

• Primer;
• Plastered;
• Repeated primer;
• Pasting paper and wallpaper;
• painting water-based varnish.

Each of these items is needed to do the job efficiently and for years to come.In theory, some of the items you can miss, but in practice, only a sequence can guarantee a good result.

Primer made by applying linseed oil or alkyd penetrant, as fiberboard perfectly absorbs moisture.If you do not do this, then the work will require a very large amount of glue.Before you begin, the entire surface is thoroughly cleaned from dust and specks and degreased with alcohol.Linseed oil is heated to 50 degrees and is applied in one layer.Also at this stage it is necessary to clean all the joints of plates, or their traces may occur after application to the surface of the wallpaper.

Important!Apply a second coat of varnish is not recommended, as it will be a long time to dry, not fully absorbed and make the surface rough.

Putty - the basis of success

Caulking is able to eliminate differences of up to 15 millimeters.After treatment, the wall is flat and smooth.Fillers can be purchased in the form of a ready mix or in the dry state.The latter option should be prepared before you start.Ready sold in buckets and bags made of polyethylene.Typically, this mixture of shrinkage that during curing reduce its volume. Therefore, to apply them for the serious alignment wall is meaningless, because the layer after drying will cracks.They are well suited for removing small defects, and finishing alignment.

wallpaper applied to the surface after using the dry putty mixtures.After the mixture dries, they do not permit the formation of cracks.But this is only possible if you follow the rules of the layer thickness.It is therefore necessary to carefully read the manufacturer's recommendations, otherwise crack layer just as shrinkage mixture.If a large thickness is required, then more than one layer.

After drying putty and it is re-primed surface.This will make it smooth and suitable for processing paper or old newspapers.Paper glued to wallpaper better and safer to pester surface.Caulking and subsequent primer must be erased to make smooth, smeared with slits.

As wallpaper glue on hardboard in detail

After preparing the surface, you can move on to the pasting.A reasonable question arises as pokleit wallpaper to MDF?The principle is the same as for the application of wallpaper on the wall.Glue is applied to the surface of fiberboard, rather than a roll.This is due to the fact that the material is perfectly absorbs moisture, so it should be well spread.It is best to use all-purpose adhesive, especially in its composition has anti-fungal additives.The proportion of water and the mixture is selected from wallpaper type.

to perform the work required a certain amount of glue.For information about the proportions and the right quantity can be read on a mixture of packages.But, in any case, it is always recommended to buy a few packs in store.When the work is completed, the wallpaper should be dry at least 48 hours.After that, the surface is covered with a simple water-based varnish to protect it from external influences.

Important!After pasting wallpaper must dry in a tightly enclosed space, that there is no draft, and air movement.Otherwise, they are peeling off and vzduyutsya.