How to drill a hole in the ceramic tile - a delicate job for DIY

Drill tiles without damage - the basic rules

difficulties when working with tiles arise due to the nature of its composition.The top ceramic layer is sufficiently strong and very fragile at the same time.When malfunction is leading to its split.Each artist must know how to make a hole in ceramic tile without damaging it.

Before drilling ceramic tiles, you need to learn a few simple rules.It is important to use a drill with speed control the speed and carbide-tipped drill bit to prevent damage.This method is suitable only for holes having a small diameter, and 15 mm.

process will require the following tools: electric drill, drill, felt-tip pen.Drill for ceramic tiles should be with a diamond tip or tipped.When you create a large diameter holes, you can use the diamond crown and the so-called "dancer".For cutting out a wide circular opening in the tiles will need a jigsaw with the string with a tungsten deposition.

Parse particular drilling tiles

Before you drill ceramic tile requires a marker to designate the center of future openings.Taps or drill, lightly tapping it with a hammer, stake the should make a mark, it will prevent the drill from slipping during operation.Begin to make the hole need only a low speed drill.Preferably done in tile holes to its mounting on the wall.

drill on glass can be used for the hole in the already laid tile.For this purpose, a place that will be affected, glued a piece of masking tape that will prevent the surface from deformation during operation.

The process is exactly the same.After the drill is replaced with one that is suitable for the wall on which to put a tile, and you can continue working.

Drilling holes in the ceramic tile is no different from making holes in other materials, but it must be carried out carefully, at low speed drill and the drill must be cooled with water from time to time.

If you want to make a hole large diameter

For Doing a big hole there are several ways.According to the marked loop holes intended going drilling ceramic tiles, that is necessary to make a lot of small holes and remove the central section carefully.Ragged can abrade bar.

This method is not very aesthetic, and requires a certain amount of time, but the goal is achieved.But still it is possible to apply the so-called "Ballerina".This type of adjustable drill, which is used for tiles and glass.It should be noted that working with "Ballerina" does not always give good results.

most effective and easiest way to make holes in the ceramic is to use a diamond bit.This special tubular-segment drill, which is used for the processing of glass, natural stone, concrete and tile.

All you need: choose the desired diameter of the crown.Although this drill is not the cheapest, but it pays for itself in savings in time and effort.It is better to buy a set of bits for the holes of different diameters.Spoil not one tile, while there will be skills to create a neat holes.