Set bath of bricks with their hands .

Installation of acrylic bathtubs on the bricks with their hands.

course, can be directly installed on a standard bath legs.However, it is worth considering that in ten years or twelve feet may start to deteriorate: porzhaveyut places where a bend.Result - lost the right slope and the water drains completely drain will not.There were times when, due to damage to the legs cracked bath itself.Therefore, it is reasonable to put the bath on the bricks.The more you need to do a little bit:

• about 20 pieces of bricks (preferably red);
• mortar;
• metal profile;
• sealant tape;
• level;
• trowel;
• hammer;
• Bulgarian;
• punch;
• screws;
• containers for mixing solution.

bottom Form of such products may be different: rectangular, oval, beveled, triangular.Therefore, the form must be suitable masonry.The height of the top of the bath from the floor must not exceed 60cm.It is also necessary to make a slope so that water freely went down the drain.Thus, the height of the front rack bath is 17cm, and the rear -. 19cm.The distance between the posts - from 50 to 60cm.

There are two ways to install:

• on the bricks.Bath (no legs) is installed only on the bricks;
• combined installation.The support is made not only on masonry, but also on the legs.

When combined method must first leg tie.Only then count the number of bricks in accordance with the free space under the tub.

After marking made of brick pillars, do masonry.It is important to remember that you can not install a bath immediately on wet cement.It should dry well - at least a day.Over the dry clutch can be applied to the mounting isolating foam.And on top of bath set.check correctness of installation mounting level.

For good shrink the foam, pour into the bath water.Then sealed joints baths with tile sealant tape.Furthermore, in such cases can use sanitary silicone.Along with the above method there is a method in a solid support of the brick base.

Set the iron and steel bath on the bricks.

It's very heavy in weight and more time consuming to install a bathtub.Therefore, it is better to install a combined way.Thus, the bath brought into the room and put it on the side - it's more convenient to connect the siphon.Pre-sold high quality siphon.Because, when you need to replace it, then do it will be very problematic.

Dimensions rack, the distance between them as described above.Cast iron tub is better to rely not only on two legs, but to make the support of the pillars on the perimeter of the bath bowl.When you install bath in the watching of support to the outer edge is higher by 0.5-1cm.of the edge that touches the wall.This is done to ensure that the floor is not poured water.

Installing steel bath on the bricks is almost the same as previous versions.But there is a small feature.Since the steel bath can bend under the weight of water, it is better to do all support under the bottom.There is another option: to put two supports several welded pipes.A very important point: these baths require that ground.If a fault is wiring grounding save accident.