Just about the complex installation of the shower tray

tools and materials to install the pallet

1. Directly pallet
2. splitter sewer
3. Siphon, most often complete
4. Tape FUM
5. Sealant
6. Hammer
7. Jigsaw
8. Screwdriver
9. pliers
10. Adjustablekey

depending on the material from which made the tray, changing the way it is installed.

Installation of acrylic trays for shower trays Acrylic

actually implemented in the form of work that allows you to quickly and seamlessly install them in the shower.The main task for the master will follow the tight connection to the sewage system and the level of installed capacity.To install not need any special tools and accessories.

Step 1: Mounting the legs to the pan and their adjustment

most often the legs to the pallet or purchased complete the attached form.

If you want to install, adjust the legs should be adjustable wrench.Due to the fact that in most homes are not perfect floor length legs exhibit in accordance with the uneven surface.It is important to align the maximum horizontal struts that water does not remain in any one corner.

Step 2: Set the drain pan to

First of all, it should mount a sewer drain with a siphon to protect against unpleasant odors from pipes.

for mounting acrylic trays, including the installation of drainage, provide complete detailed instructions for each product individually.

Step 3: finishing touches

For maximum tightness connection plate, the walls and the floor is treated with sanitary sealant (silicone).To check whether you have correctly installed the pallet should stand on its bottom.If you find a crack and deflection, this is a sure sign that somewhere you have made a mistake.But do not forget about the products in China, which is already characterized by poor quality products they have something just require further strengthening, such as brick, with foam or board.The easiest way, of course, fill the space with concrete.

Installing the shower trays made of ceramics

Ceramic trays are characterized by durability and practicality in the work.They are also easy to clean, but is not resistant to strong impact.Unlike the acrylic articles that do not form voids when installed on the floor, however, it becomes a cause that is rather difficult to reach the drain, so the pallet put close thereto.

Step 1: preparation of sewer communications

To start mark in the floor space where the sink will be located.Then create a jigsaw or a hole punch for the location of the siphon.After the second cut an opening in the floor near the first for quick access to connections and free installation.At the edges of the openings are fixed rails, and scraps of preparing access panel.Where post plan pallet smear PVA composition with water in two layers.

Step 2: Installation of the siphon to the sewer and installation of pallet

installation siphon occurs after drying the PVA.On the adhesive is necessary to put the pan so that it becomes flat.Once the solution has dried, previously left through hole (panel) connect communications.

Step 3: adjustment of joints and sealing

to the gap between the wall and the floor pan mold is not formed in the future, and other troubles, should cover the joints with silicone tape.Moreover, ceramic trays only give the appearance of strength, but in fact they are extremely fragile and require care in use.

General recommendations for the installation of shower

1. Installation capacity without legs poured cement floor and oblitsevat bumpers, if necessary, the best tiles.
2. distance between the wall and the pallet is required to seal the otherwise water will accumulate there.All joints without exception isolate.
3. Strictly follow the instructions to bought pallet.
4. sure that the bottom of the tank was above the sewer connections.
5. To check the integrity of the installation and turn on the water when it detects the flow again proizoliruyte connection.

demonstrate how to properly install the trays in the shower, may be the next video.

Luck repairs!