How to make a birdhouse his own hands

General information about birdhouse

House for feathered friends can be constructed from wood, plywood or cardboard.Usually it is placed high on the tree, under the roof, on the balcony.When choosing a place looking for a tree or a wall, so that it can not get the other animals.It is also important that the design was not in a strong wind and rain.

Also note the size and the peculiarities of the birds that inhabit the new dwelling.Small breeds (titmice, sparrows, redstart, pied flycatcher) will not be able to live in a standard birdhouse, they will be there too roomy and uncomfortable.Tryasoguzochniki should land on the ledge in front of the tap hole, and pikas live only in the triangle houses.If you do not know who to wait for a visit, take a standard structure in 30-40 cm in height, width 15-20 cm and a length of about 15-18 cm. We will tell you how to make a traditional birdhouse with their hands, how toa photo.

birdhouse made of cardboard

Wooden birdhouse for birds most reliable.It can last for several years, and in it the birds can safely deduce posterity.To work, prepare:

• wire;
• nails or screws (25-30 pieces, the length of 5 cm.);
• hacksaw;
• drill (4 cm and 5 cm in diameter);
• line;
• pencil;
• hammer or screwdriver (or a Phillips screwdriver).

Wooden board must be coniferous thickness of 2 cm most suitable width of the central part of the "facade." - 20 cm, while the side walls fit 15cm

Remember that wood must not be polished, as a bird.will not be able to cling to paws for such a base.On the smooth surface of the need to specifically make incisions.

birdhouse dimensions need to draw on paper with the drawing you bude easier to work with.

So take a picture and post it on the Saw 7 parts:

1. 3 planks, 30 cm high and 20 cm wide - for the front and rear walls, and roof).
2. 2 side wall width 15 cm;
3. 2 a square with sides of 15 cm for the bottom and top.
4. Wand - year bonds.

As you can see, nesting boxes is very easy to do with their hands.In the figure you see the standard arrangement of the components.

Once you have cut out all the details in front of the plate need to make a hole.Typically, the window is cut in a circular diameter 5 cm, but it can be square shaped.Now you can build a whole house, first to the front of nail both side walls, then set the bottom on the screws, and then nail the heel and top to attach the roof.

For mounting on the tree itself you will need a long board.At this level, you nailed her nesting box in the upper part and the middle and bottom of the base to nail to the wall or attached to a tree with wire.