Infrared Heated floor with their hands

Infrared Heated floor refers to a variety of electrical floor because is powered by electricity.However, the heat comes from the film to warm up from the copper conductors.Position the infrared heat-insulated floor with your hands is not difficult any rukasty man cope with it in a short time.Stack Infrared floor heating is possible and under the carpet, under the linoleum under the tile.View all stages of installation of the infrared floor heating can be in the photo.

Preparations

Before installing the need to define the area in whichthe film is placed.Stack infrared floor under the cabinets and sofas inappropriate.Therefore, you need to pre-designated area for which it will need to lay out.Later on the floor can not be put heavy furniture - for example, a table, chairs, armchair.The fact that gender power is directly dependent on the area that it occupies.When purchasing materials consultant must calculate the required capacity of the thermostat and the floor depending on the area facilities.

Mounting infrared heat-insulated floor with their hands

definitely need to prepare the surface before laying.The surface is cleaned, washed and checked for horizontal.If the level difference reaches 5 mm better align the pre-ground.Then prepared a place for the thermostat installation.To do this, is preparing to Stroebe to the stowed position and drill a hole in the wall to place it.The nearest outlet is carried concealed wiring to the place of its location.

To heat does not goes down in the overlap is necessary to lay the insulation.The layer thickness should be approximately 5.3 mm.If the floor is placed on the ground floor of the house can be further pave the layer of insulation under the waterproofing.

If infrared heated floor is placed under the linoleum as a heat insulator can take penoterm izolon or, if under the tiles - ideal for technical cork.Thermal insulation materials are bonded together by special adhesive tape.

Later in the way they are cut for laying wires and mounting holes.Then it made a direct installation of infrared heat-insulated floor.

film unfolds copper heaters down, at a distance of 10 - 20 cm from the walls and the meter from heat sources, such as batteries.Cut the film on a light place, between the dark areas, placed end to end without overlapping and sealed to each other and tape.

last band is also attached with tape to the insulation mats.Place the infrared film warm floor with your hands can be even one person.

Locations copper cut open areas definitely need to be insulated.It is easier to do this bitumen insulation film.To do this, cut off flaps size slightly larger than necessary and glued over open areas with 2 sides.

then pasted areas need to press into the insulation and on top of glue tape.This isolation will be effective even in case of leakage.Should remain on the surface portions only, which are mounted to the wire.

to the remaining portions of the copper clamps are attached.

When installing the clip can not damage the film, otherwise the floor will soon fail.

clip stuck in a film on the copper and pinched with pliers.

wires are attached in parallel.

It provides high-quality operation of the system when leaving one section of the building.

Stripped wire tip stuck in a hole clamp, pinched with pliers.

Junction also insulated bitumen insulation and secured with tape.More specifically, how to make an infrared heat-insulated floor, look at the video.

through the grooves in the insulation of the wire must go to the wall to the baseboards and from there to the thermostat.

All wires must also sizing tape.thermostat sensor is mounted in the center of the second section.Under it also cut a recess in the base, and under the wire leading to it - groove.

thermostat is connected conventionally.The contacts are mounted on one side of the sensor wires from the opposite side - floor heating wire, and in the central - supply.

Top laid topcoat.Installation of infrared heat-insulated floor is finished.

Video installation infrared film warm floor