Decking or how to make the floor aesthetic and environmentally friendly ?

determines that it is

Among the huge variety of decoration and building materials such board has become widespread.Attractive appearance of the floor, made of this material, its lightness, high resistance to wear and easy installation - these and many other qualities cause the high popularity of this type of cladding material.

Modern flooring - it is, material for which is dried in an autoclave timber or chipboard (DSP).On one of its faces has a thorn, and on the other (opposite) - groove. During laying planks fastened together by the method of "thorn-groove" that is, they are reduced to each other until it softly clicks .The result is a smooth finish, without any gaps, characterized excellent appearance and performance properties.

undoubted advantage of this material is that it can be used for flooring subfloors without any problems and finish coating.The structure of the board, namely the presence of grooves allows for good air circulation, so that it is eliminated rotting from excessive humidity and the formation of mold on it.

addition, the material is endowed with good heat and sound insulating properties which are of great importance in the construction.This board is an environmentally friendly material that with proper care and maintenance will last for several decades.

sheet board - select and search application

As already mentioned, this type of floor facing different kind of flexibility and is suitable for the device is not only rough, but the finishing coating.In the first case, as a rule, chosen material made from coniferous softwood.After

devices such floor is coated with lacquer or veiled carpet with high pile for more comfort when walking.Adopt a more aesthetic appearance of sheet pile board may, at its finish plastic tiles.In the second case - for finish coating, in contrast, use board of hardwood trees.

To avoid deformations of different sex, experts advise to use the boards, the humidity does not exceed 10%.

Before making a decision about whether you fit decking for the floor, it is necessary to assess the level of humidity of the room where it will be stowed. material of tree species such as pine, cedar and spruce are not the best option for industrial and residential buildings with high levels of humidity.For them much better suited solid board from larch.For a house or apartment with central heating is recommended to get the material to 10-14% moisture content.

planed wooden plank floor can be finished in a house, an apartment, on the balcony and even a sauna.Often there and the pool edge, made of this material.Lay it can be on concrete, hardboard or logs, but to achieve a perfectly flat surface is still necessary to use a special substrate.It does not only facilitate the installation of the material, but also improve the sound insulation properties of sex.

Battens decking - laying the foundations

Before laying the boards need to make sure you have the following tools and fasteners: hammer, nails, measuring tape, saws, circular saws and clamps.The wooden floor is best to lay on the joists.board thickness in this case should be approximately 20-25mm.Satisfied that after laying the lag you get a completely flat surface without unnecessary deviations can proceed directly to the floor device.

First measured the length of the wall in the room where the mounted cover, and it is cut the first board.Then it is placed against the wall spine.The distance between the wall and the board should be about 20 mm to not after the completion of coating deformation occurred as a result of compression and expansion.Then you can be taken for short board.Spike each subsequent one is inserted into the groove of the previous.

Each board nailed directly to the base floor.

In this way, the floor was covered the entire room.During stacking short board joined in places proleganiya lag.The final stacking two or three wooden fabric must have a length of an entire wall.If it is necessary, the last board is cut a circular saw to the desired width.The gap between the wall and the last board are driven wooden struts that hold the board to complete its attachment to the floor surface - nailing.

As a result of the effort and little time-consuming, you get high-quality and fairly practical flooring.If desired, the surface can be treated with special compounds that give an attractive appearance and increase the service life.