Repair Russian furnace - the traditional " weak" places such facilities

Repair Russian furnace - patient study

construction is fairly simple device.Usually it consists of a box with a brick chimney.Inside the box is mounted niche for cooking, as well as the chamber below the oven, which usually consist wood or pots.cooking niche is at a comfortable height for the hostess.

bottom of this niche has to be strong, because on it will move heavy pots or pans.Mouth (entrance to the furnace) can be closed by a special removable flap.Before the hearth (the place where the food and cooked in pans) is the hearth, which is a kind of threshold for the convenience of operating pots.Regarding

pipe, then it usually located flaps which regulate the thrust and maintain the required level of heat in the furnace.construction can often break or defects can occur at the most clutch.However, the Russian furnace repair their own hands is simple.First, you must define the problem, and then proceed to deal with it.

repair wood stoves - Diagnostics and Troubleshooting

most common breakdowns can be: small and large cracks, defects in welds or masonry, the lack of traction, falling bricks, furnace oil smoke, loose closing the furnace door.To carry out all the work necessary to choose the appropriate tools: hammer, nails, chisels, trowels.From the materials to work necessarily need mortar to repair the furnace.

repair wood stoves is no different from other types of repair facilities.First you need to determine the extent of the defect.If masonry There are small or large cracks, you need to be sure to clean the debris from the crack and mortar, moisten the surface and cover up with a solution.The solution may also be a clay, and with the addition of salt.

If the stove has a problem with the joints, in some cases, understands masonry and repair of furnaces produced by shifting bricks and correcting structural building inaccuracies.In the absence of traction, above all, we need to clean the chimney soot accumulation.

If there was a chimney air lock, it is necessary to use an oven to burn paper in it.The procedure is done as long as the tube does not match the buzz appears.Therefore, in order to keep it from igniting when smoked, it should always be the first thing to warm it before the main combustion chamber.

furnace repair their own hands - correcting mechanisms associated

If you experience problems with the furnace door, then you just need to disassemble the clutch, expand it, re-mount the box door and secure it with a solution.After complete drying of the solution can be installed door.

When replacing the grates must be well clean the support surface.Moreover grate or grid must be laid so as to leave a gap of 5 mm (metal expands when heated and can damage the clutch) between the masonry and the edges of the lattice.

If the plaster has fallen off, it is necessary to remove all the old plaster finish and the oven again.It is also to be replaced predtopochnye sheets, if they already have holes. If necessary, you can change a name of where the pan while cooking.To this end, the foundation is well aligned and spread under the bricks 25x25 cm.

Repair of bath furnace is no different from other types of repairs, since similar damage and defects can be detected in all the heating furnaces.Repair of heating stoves - a serious matter, so if you are not sure you can do it right, it is better to trust the professionals.