Build Daily

Heating Installation

August 12, 2017 18:07

Wiring electrode boiler 220 and 380 Volt

click fraud protection
Recently we told you how to make an electrode boiler with his hands.Really interesting idea, because not spend so much time on a device and also used for this handy tools.Today I would like to tell you, what are the wiring diagram of the electrode boiler to electricity and heating.The fact that this type of heater may be output as 3 and 9 kW.In the first case, a network approach 220 volts, then at 9 kilowatts can not do without three-phase wiring.Two versions of the connection we now consider!

Contents:
  • single-phase three-phase network

single phase

If a small capacity of the device (up to 7 kW), it may be connected to 220 V. In this case, it is recommendedconduct phase breaking through the machine, and zero directly from the distribution panel bus.Also, be sure to connect the ground to the body of the cylinder, to protect yourself from electrical shock.

So, the simplest electrical wiring diagram of the electrode heating boiler as follows: Installation via the magnetic contactor

Magnetic starter simplifies equipment management.When the temperature exceeds the thermostat set point (or vice versa falls below), magnetic starter enable / disable the electric boiler.It is very convenient and allows you to make automatic heating system.

to the heating system, water heater is connected so: The heating system in the house

Three phase

If you want to connect a high-power electric boiler, it is necessary to use three phases.Wiring ion boiler 380 volts should be such: Connecting to the three phases

There is already wiring harness a bit more complicated.As you can see, the three phases, first go to the vending machines, and from one phase conductor made of wire tap on a separate single-pole machine, which serves the circulation pump.From the circuit breaker is powered by magnetic actuators, and with him already to the terminals of the boiler.Ground wire is connected to each device separately: pump, thermostat, water heater.Do not forget about the ground, it is necessary to connect with their own hands for the special terminal on the housing.

Several popular connection diagrams You can also view the video:

Overview connection options

YouTube Preview

If you are interested in the connection diagram of the electrode boiler as a backup sourceheating, then we recommend that you read this installation option: Back home heating

wires are connected with one of the above methods or to 220 or to 380 V. It is also recommended to view the video, which clearly shows the entire process of installation:

Connecting the boiler to the network
YouTube Preview

Here we are given a typical wiring diagram of the electrode heating boiler to the electricity and the heating system itself.The popular manufacturer of water heaters - Galan firm recommends to conduct each phase of a separate single-pole three-phase electrical machine.Thus, it is possible to manually adjust the heating power by turning off or vice versa, including the power to each electrode.

Also read:

  • How do
  • induction boiler own hands How to make independent heating apartments
  • Wire Colors
instagram viewer