A device with a soft roof - a dry room without effort

process effortless

repair and a soft roof can fulfill almost every self.If there are available all the necessary tools to carry out this work, the process is quite simple.Installation is usually done together.One of the workers heats the roofing material of the gas burner to the desired temperature, and the second behind him evenly roll rolls.

can also work himself, with the roll out roofing claw or rebar with a special bend at the end.However, experts say that, if there is a misalignment of roofing material, will not claw his fix.It will have to put off the burner and manually correct the material that is time-consuming.In this regard, it is recommended to work with an assistant.

After performing operations on the entire roof area, check the quality of work.All rolls should lie in neat rows at an angle.In addition, it is necessary to carefully check the edge.They must be well secured, or in the wind, they bent, and roofing material will break.If outwardly everything looks fine, it is necessary to wait for the rain, in fact it shows the quality of the work performed.

Important!When the paving is necessary to adhere to all rules and regulations of quality work.

materials and tools you'll need:

• Ruberoid;
• gas burner or a torch;
• knife for cutting the material;
• broom to remove debris;
• protection (thick pants and shoes, gloves).

device adjacencies

Particular attention should be given to how to perform the device adjacency soft roof.In the process of establishing adjacencies on the joints of the material and the roof is attached special triangular rake.Its role can be a baseboard or wooden beams.Further, in this timber is put soft roof.If the surface is made of brick, before starting the installation process it is necessary primer.In order to ensure sealing and ventilation chimneys, is the valley of the pattern of the carpet or sheet of metal that is resistant to corrosion.Also, the installation must be taken into account The Cascade water.

Important!Adjacencies must be very careful to overlap, since they can leak through moisture, which will accelerate the need for repairs.

In areas with snowy winters need to ensure snow retention system.Such a system is established at the time of soft roof, and it is necessary for the protection of drainage systems from the damage caused by snowmelt from the roof.These systems are available in two types: Point and Line Midway.It is best to use a point as they go under the roof, which gives it extra protection.

Repair coating technology

soft roofing is very simple, which is what makes it so popular.However, as mentioned above, it is necessary every few years to carry out its repair.There are two types of roof repairs: overhaul and imposing Latok.

Overlay Latok used in cases where, in general, cover more normal and only in some places appeared defects.Such areas shall be exempt from the old pavement and stripped.The patch can be made from the same material as the coating itself, or using any other suitable material.It is important to apply the bituminous mastic on the inside of the patches.It should be at least five centimeters to act outside the territory of the treated area.Then it is heated, pressed and put the load on top.

Overhaul - enough time-consuming process.To do this, remove all the old paint, clean the surface of the roof and process it.Further roofing performed as described earlier.The best way to see a variety of educational videos about the soft roofing, video will more clearly understand the operation.

Note! Overhaul - a complex process, so if there is any doubt as self-fulfillment, it is better to turn to professionals.